Commit 44b37eb7 authored by leilk.liu's avatar leilk.liu Committed by Mark Brown

spi: mediatek: use correct SPI_CFG2_REG MACRO

this patch use correct SPI_CFG2_REG offset.
Signed-off-by: default avatarleilk.liu <leilk.liu@mediatek.com>
Link: https://lore.kernel.org/r/20200701090020.7935-1-leilk.liu@mediatek.comSigned-off-by: default avatarMark Brown <broonie@kernel.org>
parent cf961fce
......@@ -36,7 +36,6 @@
#define SPI_CFG0_SCK_LOW_OFFSET 8
#define SPI_CFG0_CS_HOLD_OFFSET 16
#define SPI_CFG0_CS_SETUP_OFFSET 24
#define SPI_ADJUST_CFG0_SCK_LOW_OFFSET 16
#define SPI_ADJUST_CFG0_CS_HOLD_OFFSET 0
#define SPI_ADJUST_CFG0_CS_SETUP_OFFSET 16
......@@ -48,6 +47,8 @@
#define SPI_CFG1_CS_IDLE_MASK 0xff
#define SPI_CFG1_PACKET_LOOP_MASK 0xff00
#define SPI_CFG1_PACKET_LENGTH_MASK 0x3ff0000
#define SPI_CFG2_SCK_HIGH_OFFSET 0
#define SPI_CFG2_SCK_LOW_OFFSET 16
#define SPI_CMD_ACT BIT(0)
#define SPI_CMD_RESUME BIT(1)
......@@ -283,7 +284,7 @@ static void mtk_spi_set_cs(struct spi_device *spi, bool enable)
static void mtk_spi_prepare_transfer(struct spi_master *master,
struct spi_transfer *xfer)
{
u32 spi_clk_hz, div, sck_time, cs_time, reg_val = 0;
u32 spi_clk_hz, div, sck_time, cs_time, reg_val;
struct mtk_spi *mdata = spi_master_get_devdata(master);
spi_clk_hz = clk_get_rate(mdata->spi_clk);
......@@ -296,18 +297,18 @@ static void mtk_spi_prepare_transfer(struct spi_master *master,
cs_time = sck_time * 2;
if (mdata->dev_comp->enhance_timing) {
reg_val = (((sck_time - 1) & 0xffff)
<< SPI_CFG2_SCK_HIGH_OFFSET);
reg_val |= (((sck_time - 1) & 0xffff)
<< SPI_CFG0_SCK_HIGH_OFFSET);
reg_val |= (((sck_time - 1) & 0xffff)
<< SPI_ADJUST_CFG0_SCK_LOW_OFFSET);
<< SPI_CFG2_SCK_LOW_OFFSET);
writel(reg_val, mdata->base + SPI_CFG2_REG);
reg_val |= (((cs_time - 1) & 0xffff)
reg_val = (((cs_time - 1) & 0xffff)
<< SPI_ADJUST_CFG0_CS_HOLD_OFFSET);
reg_val |= (((cs_time - 1) & 0xffff)
<< SPI_ADJUST_CFG0_CS_SETUP_OFFSET);
writel(reg_val, mdata->base + SPI_CFG0_REG);
} else {
reg_val |= (((sck_time - 1) & 0xff)
reg_val = (((sck_time - 1) & 0xff)
<< SPI_CFG0_SCK_HIGH_OFFSET);
reg_val |= (((sck_time - 1) & 0xff) << SPI_CFG0_SCK_LOW_OFFSET);
reg_val |= (((cs_time - 1) & 0xff) << SPI_CFG0_CS_HOLD_OFFSET);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment