Commit 472796de authored by Abhishek Sahu's avatar Abhishek Sahu Committed by Stephen Boyd

clk: qcom: support for dynamic updating the PLL

Some of the Alpha PLLs support dynamic update in which the
frequency can be changed dynamically without turning off the PLL.

This dynamic update requires the following sequence:

 1. Write the desired values to L_VAL and ALPHA_VAL registers
 2. Toggle pll_latch_input from low to high
 3. Wait for pll_ack_latch to transition from low to high
    The new L and alpha values have been latched. It may
    take some time for the PLL to fully settle with these
    new values.
 4. Pull pll_latch_input low
Signed-off-by: default avatarRajendra Nayak <rnayak@codeaurora.org>
Signed-off-by: default avatarTaniya Das <tdas@codeaurora.org>
Signed-off-by: default avatarAbhishek Sahu <absahu@codeaurora.org>
Signed-off-by: default avatarStephen Boyd <sboyd@codeaurora.org>
parent c45ae598
...@@ -32,7 +32,10 @@ ...@@ -32,7 +32,10 @@
# define PLL_VOTE_FSM_ENA BIT(20) # define PLL_VOTE_FSM_ENA BIT(20)
# define PLL_FSM_ENA BIT(20) # define PLL_FSM_ENA BIT(20)
# define PLL_VOTE_FSM_RESET BIT(21) # define PLL_VOTE_FSM_RESET BIT(21)
# define PLL_UPDATE BIT(22)
# define PLL_UPDATE_BYPASS BIT(23)
# define PLL_OFFLINE_ACK BIT(28) # define PLL_OFFLINE_ACK BIT(28)
# define ALPHA_PLL_ACK_LATCH BIT(29)
# define PLL_ACTIVE_FLAG BIT(30) # define PLL_ACTIVE_FLAG BIT(30)
# define PLL_LOCK_DET BIT(31) # define PLL_LOCK_DET BIT(31)
...@@ -130,6 +133,15 @@ static int wait_for_pll(struct clk_alpha_pll *pll, u32 mask, bool inverse, ...@@ -130,6 +133,15 @@ static int wait_for_pll(struct clk_alpha_pll *pll, u32 mask, bool inverse,
#define wait_for_pll_offline(pll) \ #define wait_for_pll_offline(pll) \
wait_for_pll(pll, PLL_OFFLINE_ACK, 0, "offline") wait_for_pll(pll, PLL_OFFLINE_ACK, 0, "offline")
#define wait_for_pll_update(pll) \
wait_for_pll(pll, PLL_UPDATE, 1, "update")
#define wait_for_pll_update_ack_set(pll) \
wait_for_pll(pll, ALPHA_PLL_ACK_LATCH, 0, "update_ack_set")
#define wait_for_pll_update_ack_clear(pll) \
wait_for_pll(pll, ALPHA_PLL_ACK_LATCH, 1, "update_ack_clear")
void clk_alpha_pll_configure(struct clk_alpha_pll *pll, struct regmap *regmap, void clk_alpha_pll_configure(struct clk_alpha_pll *pll, struct regmap *regmap,
const struct alpha_pll_config *config) const struct alpha_pll_config *config)
{ {
...@@ -402,8 +414,57 @@ clk_alpha_pll_recalc_rate(struct clk_hw *hw, unsigned long parent_rate) ...@@ -402,8 +414,57 @@ clk_alpha_pll_recalc_rate(struct clk_hw *hw, unsigned long parent_rate)
return alpha_pll_calc_rate(prate, l, a, alpha_width); return alpha_pll_calc_rate(prate, l, a, alpha_width);
} }
static int clk_alpha_pll_set_rate(struct clk_hw *hw, unsigned long rate, static int clk_alpha_pll_update_latch(struct clk_alpha_pll *pll,
unsigned long prate) int (*is_enabled)(struct clk_hw *))
{
int ret;
u32 mode;
if (!is_enabled(&pll->clkr.hw) ||
!(pll->flags & SUPPORTS_DYNAMIC_UPDATE))
return 0;
regmap_read(pll->clkr.regmap, PLL_MODE(pll), &mode);
/* Latch the input to the PLL */
regmap_update_bits(pll->clkr.regmap, PLL_MODE(pll), PLL_UPDATE,
PLL_UPDATE);
/* Wait for 2 reference cycle before checking ACK bit */
udelay(1);
/*
* PLL will latch the new L, Alpha and freq control word.
* PLL will respond by raising PLL_ACK_LATCH output when new programming
* has been latched in and PLL is being updated. When
* UPDATE_LOGIC_BYPASS bit is not set, PLL_UPDATE will be cleared
* automatically by hardware when PLL_ACK_LATCH is asserted by PLL.
*/
if (mode & PLL_UPDATE_BYPASS) {
ret = wait_for_pll_update_ack_set(pll);
if (ret)
return ret;
regmap_update_bits(pll->clkr.regmap, PLL_MODE(pll), PLL_UPDATE, 0);
} else {
ret = wait_for_pll_update(pll);
if (ret)
return ret;
}
ret = wait_for_pll_update_ack_clear(pll);
if (ret)
return ret;
/* Wait for PLL output to stabilize */
udelay(10);
return 0;
}
static int __clk_alpha_pll_set_rate(struct clk_hw *hw, unsigned long rate,
unsigned long prate,
int (*is_enabled)(struct clk_hw *))
{ {
struct clk_alpha_pll *pll = to_clk_alpha_pll(hw); struct clk_alpha_pll *pll = to_clk_alpha_pll(hw);
const struct pll_vco *vco; const struct pll_vco *vco;
...@@ -434,7 +495,21 @@ static int clk_alpha_pll_set_rate(struct clk_hw *hw, unsigned long rate, ...@@ -434,7 +495,21 @@ static int clk_alpha_pll_set_rate(struct clk_hw *hw, unsigned long rate,
regmap_update_bits(pll->clkr.regmap, PLL_USER_CTL(pll), regmap_update_bits(pll->clkr.regmap, PLL_USER_CTL(pll),
PLL_ALPHA_EN, PLL_ALPHA_EN); PLL_ALPHA_EN, PLL_ALPHA_EN);
return 0; return clk_alpha_pll_update_latch(pll, is_enabled);
}
static int clk_alpha_pll_set_rate(struct clk_hw *hw, unsigned long rate,
unsigned long prate)
{
return __clk_alpha_pll_set_rate(hw, rate, prate,
clk_alpha_pll_is_enabled);
}
static int clk_alpha_pll_hwfsm_set_rate(struct clk_hw *hw, unsigned long rate,
unsigned long prate)
{
return __clk_alpha_pll_set_rate(hw, rate, prate,
clk_alpha_pll_hwfsm_is_enabled);
} }
static long clk_alpha_pll_round_rate(struct clk_hw *hw, unsigned long rate, static long clk_alpha_pll_round_rate(struct clk_hw *hw, unsigned long rate,
...@@ -471,7 +546,7 @@ const struct clk_ops clk_alpha_pll_hwfsm_ops = { ...@@ -471,7 +546,7 @@ const struct clk_ops clk_alpha_pll_hwfsm_ops = {
.is_enabled = clk_alpha_pll_hwfsm_is_enabled, .is_enabled = clk_alpha_pll_hwfsm_is_enabled,
.recalc_rate = clk_alpha_pll_recalc_rate, .recalc_rate = clk_alpha_pll_recalc_rate,
.round_rate = clk_alpha_pll_round_rate, .round_rate = clk_alpha_pll_round_rate,
.set_rate = clk_alpha_pll_set_rate, .set_rate = clk_alpha_pll_hwfsm_set_rate,
}; };
EXPORT_SYMBOL_GPL(clk_alpha_pll_hwfsm_ops); EXPORT_SYMBOL_GPL(clk_alpha_pll_hwfsm_ops);
......
...@@ -60,6 +60,7 @@ struct clk_alpha_pll { ...@@ -60,6 +60,7 @@ struct clk_alpha_pll {
size_t num_vco; size_t num_vco;
#define SUPPORTS_OFFLINE_REQ BIT(0) #define SUPPORTS_OFFLINE_REQ BIT(0)
#define SUPPORTS_FSM_MODE BIT(2) #define SUPPORTS_FSM_MODE BIT(2)
#define SUPPORTS_DYNAMIC_UPDATE BIT(3)
u8 flags; u8 flags;
struct clk_regmap clkr; struct clk_regmap clkr;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment