Commit 4872b11f authored by Guo-Fu Tseng's avatar Guo-Fu Tseng Committed by David S. Miller

jme: PHY Power control for new chip

After main chip rev 5, the hardware support more power saving
control registers.
Some Non-Linux drivers might turn off the phy power with new
interfaces, this patch makes it possible for Linux to turn it
on again.
Signed-off-by: default avatarGuo-Fu Tseng <cooldavid@cooldavid.org>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 19d96017
......@@ -1576,6 +1576,38 @@ jme_free_irq(struct jme_adapter *jme)
}
}
static inline void
jme_new_phy_on(struct jme_adapter *jme)
{
u32 reg;
reg = jread32(jme, JME_PHY_PWR);
reg &= ~(PHY_PWR_DWN1SEL | PHY_PWR_DWN1SW |
PHY_PWR_DWN2 | PHY_PWR_CLKSEL);
jwrite32(jme, JME_PHY_PWR, reg);
pci_read_config_dword(jme->pdev, PCI_PRIV_PE1, &reg);
reg &= ~PE1_GPREG0_PBG;
reg |= PE1_GPREG0_ENBG;
pci_write_config_dword(jme->pdev, PCI_PRIV_PE1, reg);
}
static inline void
jme_new_phy_off(struct jme_adapter *jme)
{
u32 reg;
reg = jread32(jme, JME_PHY_PWR);
reg |= PHY_PWR_DWN1SEL | PHY_PWR_DWN1SW |
PHY_PWR_DWN2 | PHY_PWR_CLKSEL;
jwrite32(jme, JME_PHY_PWR, reg);
pci_read_config_dword(jme->pdev, PCI_PRIV_PE1, &reg);
reg &= ~PE1_GPREG0_PBG;
reg |= PE1_GPREG0_PDD3COLD;
pci_write_config_dword(jme->pdev, PCI_PRIV_PE1, reg);
}
static inline void
jme_phy_on(struct jme_adapter *jme)
{
......@@ -1584,6 +1616,22 @@ jme_phy_on(struct jme_adapter *jme)
bmcr = jme_mdio_read(jme->dev, jme->mii_if.phy_id, MII_BMCR);
bmcr &= ~BMCR_PDOWN;
jme_mdio_write(jme->dev, jme->mii_if.phy_id, MII_BMCR, bmcr);
if (new_phy_power_ctrl(jme->chip_main_rev))
jme_new_phy_on(jme);
}
static inline void
jme_phy_off(struct jme_adapter *jme)
{
u32 bmcr;
bmcr = jme_mdio_read(jme->dev, jme->mii_if.phy_id, MII_BMCR);
bmcr |= BMCR_PDOWN;
jme_mdio_write(jme->dev, jme->mii_if.phy_id, MII_BMCR, bmcr);
if (new_phy_power_ctrl(jme->chip_main_rev))
jme_new_phy_off(jme);
}
static int
......@@ -1606,12 +1654,11 @@ jme_open(struct net_device *netdev)
jme_start_irq(jme);
if (test_bit(JME_FLAG_SSET, &jme->flags)) {
jme_phy_on(jme);
jme_phy_on(jme);
if (test_bit(JME_FLAG_SSET, &jme->flags))
jme_set_settings(netdev, &jme->old_ecmd);
} else {
else
jme_reset_phy_processor(jme);
}
jme_reset_link(jme);
......@@ -1657,12 +1704,6 @@ jme_wait_link(struct jme_adapter *jme)
}
}
static inline void
jme_phy_off(struct jme_adapter *jme)
{
jme_mdio_write(jme->dev, jme->mii_if.phy_id, MII_BMCR, BMCR_PDOWN);
}
static void
jme_powersave_phy(struct jme_adapter *jme)
{
......@@ -3068,12 +3109,11 @@ jme_resume(struct pci_dev *pdev)
jme_clear_pm(jme);
pci_restore_state(pdev);
if (test_bit(JME_FLAG_SSET, &jme->flags)) {
jme_phy_on(jme);
jme_phy_on(jme);
if (test_bit(JME_FLAG_SSET, &jme->flags))
jme_set_settings(netdev, &jme->old_ecmd);
} else {
else
jme_reset_phy_processor(jme);
}
jme_start_irq(jme);
netif_device_attach(netdev);
......
......@@ -103,6 +103,37 @@ enum jme_spi_op_bits {
#define HALF_US 500 /* 500 ns */
#define JMESPIIOCTL SIOCDEVPRIVATE
#define PCI_PRIV_PE1 0xE4
enum pci_priv_pe1_bit_masks {
PE1_ASPMSUPRT = 0x00000003, /*
* RW:
* Aspm_support[1:0]
* (R/W Port of 5C[11:10])
*/
PE1_MULTIFUN = 0x00000004, /* RW: Multi_fun_bit */
PE1_RDYDMA = 0x00000008, /* RO: ~link.rdy_for_dma */
PE1_ASPMOPTL = 0x00000030, /* RW: link.rx10s_option[1:0] */
PE1_ASPMOPTH = 0x000000C0, /* RW: 10_req=[3]?HW:[2] */
PE1_GPREG0 = 0x0000FF00, /*
* SRW:
* Cfg_gp_reg0
* [7:6] phy_giga BG control
* [5] CREQ_N as CREQ_N1 (CPPE# as CREQ#)
* [4:0] Reserved
*/
PE1_GPREG0_PBG = 0x0000C000, /* phy_giga BG control */
PE1_GPREG1 = 0x00FF0000, /* RW: Cfg_gp_reg1 */
PE1_REVID = 0xFF000000, /* RO: Rev ID */
};
enum pci_priv_pe1_values {
PE1_GPREG0_ENBG = 0x00000000, /* en BG */
PE1_GPREG0_PDD3COLD = 0x00004000, /* giga_PD + d3cold */
PE1_GPREG0_PDPCIESD = 0x00008000, /* giga_PD + pcie_shutdown */
PE1_GPREG0_PDPCIEIDDQ = 0x0000C000, /* giga_PD + pcie_iddq */
};
/*
* Dynamic(adaptive)/Static PCC values
*/
......@@ -499,6 +530,7 @@ enum jme_iomap_regs {
JME_PMCS = JME_MAC | 0x60, /* Power Management Control/Stat */
JME_PHY_PWR = JME_PHY | 0x24, /* New PHY Power Ctrl Register */
JME_PHY_CS = JME_PHY | 0x28, /* PHY Ctrl and Status Register */
JME_PHY_LINK = JME_PHY | 0x30, /* PHY Link Status Register */
JME_SMBCSR = JME_PHY | 0x40, /* SMB Control and Status */
......@@ -834,6 +866,21 @@ enum jme_pmcs_bit_masks {
PMCS_MFEN = 0x00000001,
};
/*
* New PHY Power Control Register
*/
enum jme_phy_pwr_bit_masks {
PHY_PWR_DWN1SEL = 0x01000000, /* Phy_giga.p_PWR_DOWN1_SEL */
PHY_PWR_DWN1SW = 0x02000000, /* Phy_giga.p_PWR_DOWN1_SW */
PHY_PWR_DWN2 = 0x04000000, /* Phy_giga.p_PWR_DOWN2 */
PHY_PWR_CLKSEL = 0x08000000, /*
* XTL_OUT Clock select
* (an internal free-running clock)
* 0: xtl_out = phy_giga.A_XTL25_O
* 1: xtl_out = phy_giga.PD_OSC
*/
};
/*
* Giga PHY Status Registers
*/
......@@ -1191,6 +1238,11 @@ static inline int is_buggy250(unsigned short device, u8 chiprev)
return device == PCI_DEVICE_ID_JMICRON_JMC250 && chiprev == 0x11;
}
static inline int new_phy_power_ctrl(u8 chip_main_rev)
{
return chip_main_rev >= 5;
}
/*
* Function prototypes
*/
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment