scsi: lpfc: enhance LE data structure copies to hardware

The driver builds the control structures in host memory using
definitions that are based on 32-bit words. After building the structure
it is then written to the adapter.

This patch slightly optimizes LE hosts by copying the structures via
64-bit copies.  This is doable as the adapter interface is LE thus there
is no byteswapping as the copy is performed.

The same optimization would be nice on BE systems, but when byteswapping
occurs, it swaps 32-bit words as well, thus trashing the control
structure. Given amount of code that is dependent upon the 32-bit word
definition, it was decided to not change things for the minor
optimization. Thus PPC 64-bit systems sticks with doing 32-bit copies.
Signed-off-by: Dick Kennedy <dick.kennedy@broadcom.com>
Signed-off-by: James Smart <james.smart@broadcom.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

drivers/scsi/lpfc/lpfc_sli.c

@@ -96,6 +96,34 @@ lpfc_get_iocb_from_iocbq(struct lpfc_iocbq *iocbq)
 	return &iocbq->iocb;
 }
 
+#if defined(CONFIG_64BIT) && defined(__LITTLE_ENDIAN)
+/**
+ * lpfc_sli4_pcimem_bcopy - SLI4 memory copy function
+ * @srcp: Source memory pointer.
+ * @destp: Destination memory pointer.
+ * @cnt: Number of words required to be copied.
+ *       Must be a multiple of sizeof(uint64_t)
+ *
+ * This function is used for copying data between driver memory
+ * and the SLI WQ. This function also changes the endianness
+ * of each word if native endianness is different from SLI
+ * endianness. This function can be called with or without
+ * lock.
+ **/
+void
+lpfc_sli4_pcimem_bcopy(void *srcp, void *destp, uint32_t cnt)
+{
+	uint64_t *src = srcp;
+	uint64_t *dest = destp;
+	int i;
+
+	for (i = 0; i < (int)cnt; i += sizeof(uint64_t))
+		*dest++ = *src++;
+}
+#else
+#define lpfc_sli4_pcimem_bcopy(a, b, c) lpfc_sli_pcimem_bcopy(a, b, c)
+#endif
+
 /**
  * lpfc_sli4_wq_put - Put a Work Queue Entry on an Work Queue
  * @q: The Work Queue to operate on.
@@ -137,7 +165,7 @@ lpfc_sli4_wq_put(struct lpfc_queue *q, union lpfc_wqe128 *wqe)
 		bf_set(wqe_wqec, &wqe->generic.wqe_com, 0);
 	if (q->phba->sli3_options & LPFC_SLI4_PHWQ_ENABLED)
 		bf_set(wqe_wqid, &wqe->generic.wqe_com, q->queue_id);
-	lpfc_sli_pcimem_bcopy(wqe, temp_wqe, q->entry_size);
+	lpfc_sli4_pcimem_bcopy(wqe, temp_wqe, q->entry_size);
 	if (q->dpp_enable && q->phba->cfg_enable_dpp) {
 		/* write to DPP aperture taking advatage of Combined Writes */
 		tmp = (uint8_t *)temp_wqe;
@@ -240,7 +268,7 @@ lpfc_sli4_mq_put(struct lpfc_queue *q, struct lpfc_mqe *mqe)
 	/* If the host has not yet processed the next entry then we are done */
 	if (((q->host_index + 1) % q->entry_count) == q->hba_index)
 		return -ENOMEM;
-	lpfc_sli_pcimem_bcopy(mqe, temp_mqe, q->entry_size);
+	lpfc_sli4_pcimem_bcopy(mqe, temp_mqe, q->entry_size);
 	/* Save off the mailbox pointer for completion */
 	q->phba->mbox = (MAILBOX_t *)temp_mqe;
 
@@ -663,8 +691,8 @@ lpfc_sli4_rq_put(struct lpfc_queue *hq, struct lpfc_queue *dq,
 	/* If the host has not yet processed the next entry then we are done */
 	if (((hq_put_index + 1) % hq->entry_count) == hq->hba_index)
 		return -EBUSY;
-	lpfc_sli_pcimem_bcopy(hrqe, temp_hrqe, hq->entry_size);
-	lpfc_sli_pcimem_bcopy(drqe, temp_drqe, dq->entry_size);
+	lpfc_sli4_pcimem_bcopy(hrqe, temp_hrqe, hq->entry_size);
+	lpfc_sli4_pcimem_bcopy(drqe, temp_drqe, dq->entry_size);
 
 	/* Update the host index to point to the next slot */
 	hq->host_index = ((hq_put_index + 1) % hq->entry_count);
@@ -8185,8 +8213,8 @@ lpfc_sli4_post_sync_mbox(struct lpfc_hba *phba, LPFC_MBOXQ_t *mboxq)
 	 */
 	mbx_cmnd = bf_get(lpfc_mqe_command, mb);
 	memset(phba->sli4_hba.bmbx.avirt, 0, sizeof(struct lpfc_bmbx_create));
-	lpfc_sli_pcimem_bcopy(mb, phba->sli4_hba.bmbx.avirt,
-			      sizeof(struct lpfc_mqe));
+	lpfc_sli4_pcimem_bcopy(mb, phba->sli4_hba.bmbx.avirt,
+			       sizeof(struct lpfc_mqe));
 
 	/* Post the high mailbox dma address to the port and wait for ready. */
 	dma_address = &phba->sli4_hba.bmbx.dma_address;
@@ -8210,11 +8238,11 @@ lpfc_sli4_post_sync_mbox(struct lpfc_hba *phba, LPFC_MBOXQ_t *mboxq)
 	 * If so, update the mailbox status so that the upper layers
 	 * can complete the request normally.
 	 */
-	lpfc_sli_pcimem_bcopy(phba->sli4_hba.bmbx.avirt, mb,
-			      sizeof(struct lpfc_mqe));
+	lpfc_sli4_pcimem_bcopy(phba->sli4_hba.bmbx.avirt, mb,
+			       sizeof(struct lpfc_mqe));
 	mbox_rgn = (struct lpfc_bmbx_create *) phba->sli4_hba.bmbx.avirt;
-	lpfc_sli_pcimem_bcopy(&mbox_rgn->mcqe, &mboxq->mcqe,
-			      sizeof(struct lpfc_mcqe));
+	lpfc_sli4_pcimem_bcopy(&mbox_rgn->mcqe, &mboxq->mcqe,
+			       sizeof(struct lpfc_mcqe));
 	mcqe_status = bf_get(lpfc_mcqe_status, &mbox_rgn->mcqe);
 	/*
 	 * When the CQE status indicates a failure and the mailbox status
@@ -12830,7 +12858,7 @@ lpfc_sli4_sp_handle_mbox_event(struct lpfc_hba *phba, struct lpfc_mcqe *mcqe)
 
 	/* Move mbox data to caller's mailbox region, do endian swapping */
 	if (pmb->mbox_cmpl && mbox)
-		lpfc_sli_pcimem_bcopy(mbox, mqe, sizeof(struct lpfc_mqe));
+		lpfc_sli4_pcimem_bcopy(mbox, mqe, sizeof(struct lpfc_mqe));
 
 	/*
 	 * For mcqe errors, conditionally move a modified error code to
@@ -12913,7 +12941,7 @@ lpfc_sli4_sp_handle_mcqe(struct lpfc_hba *phba, struct lpfc_cqe *cqe)
 	bool workposted;
 
 	/* Copy the mailbox MCQE and convert endian order as needed */
-	lpfc_sli_pcimem_bcopy(cqe, &mcqe, sizeof(struct lpfc_mcqe));
+	lpfc_sli4_pcimem_bcopy(cqe, &mcqe, sizeof(struct lpfc_mcqe));
 
 	/* Invoke the proper event handling routine */
 	if (!bf_get(lpfc_trailer_async, &mcqe))
@@ -13173,7 +13201,7 @@ lpfc_sli4_sp_handle_cqe(struct lpfc_hba *phba, struct lpfc_queue *cq,
 	bool workposted = false;
 
 	/* Copy the work queue CQE and convert endian order if needed */
-	lpfc_sli_pcimem_bcopy(cqe, &cqevt, sizeof(struct lpfc_cqe));
+	lpfc_sli4_pcimem_bcopy(cqe, &cqevt, sizeof(struct lpfc_cqe));
 
 	/* Check and process for different type of WCQE and dispatch */
 	switch (bf_get(lpfc_cqe_code, &cqevt)) {
@@ -13581,7 +13609,7 @@ lpfc_sli4_fp_handle_cqe(struct lpfc_hba *phba, struct lpfc_queue *cq,
 	bool workposted = false;
 
 	/* Copy the work queue CQE and convert endian order if needed */
-	lpfc_sli_pcimem_bcopy(cqe, &wcqe, sizeof(struct lpfc_cqe));
+	lpfc_sli4_pcimem_bcopy(cqe, &wcqe, sizeof(struct lpfc_cqe));
 
 	/* Check and process for different type of WCQE and dispatch */
 	switch (bf_get(lpfc_wcqe_c_code, &wcqe)) {