Commit 4a2c5ddd authored by Jai Luthra's avatar Jai Luthra Committed by Vignesh Raghavendra

arm64: dts: ti: k3-am62a7-sk: Enable audio on AM62A

Add nodes for audio codec and sound card, enable the audio serializer
(McASP1) under use and update pinmux.
Reviewed-by: default avatarJayesh Choudhary <j-choudhary@ti.com>
Reviewed-by: default avatarDevarsh Thakkar <devarsht@ti.com>
Link: https://www.ti.com/lit/zip/sprr459Signed-off-by: default avatarJai Luthra <j-luthra@ti.com>
Link: https://lore.kernel.org/r/20231003-mcasp_am62a-v3-5-2b631ff319ca@ti.comSigned-off-by: default avatarVignesh Raghavendra <vigneshr@ti.com>
parent 3a822208
......@@ -125,6 +125,41 @@ led-0 {
default-state = "off";
};
};
tlv320_mclk: clk-0 {
#clock-cells = <0>;
compatible = "fixed-clock";
clock-frequency = <12288000>;
};
codec_audio: sound {
compatible = "simple-audio-card";
simple-audio-card,name = "AM62Ax-SKEVM";
simple-audio-card,widgets =
"Headphone", "Headphone Jack",
"Line", "Line In",
"Microphone", "Microphone Jack";
simple-audio-card,routing =
"Headphone Jack", "HPLOUT",
"Headphone Jack", "HPROUT",
"LINE1L", "Line In",
"LINE1R", "Line In",
"MIC3R", "Microphone Jack",
"Microphone Jack", "Mic Bias";
simple-audio-card,format = "dsp_b";
simple-audio-card,bitclock-master = <&sound_master>;
simple-audio-card,frame-master = <&sound_master>;
simple-audio-card,bitclock-inversion;
simple-audio-card,cpu {
sound-dai = <&mcasp1>;
};
sound_master: simple-audio-card,codec {
sound-dai = <&tlv320aic3106>;
clocks = <&tlv320_mclk>;
};
};
};
&mcu_pmx0 {
......@@ -230,6 +265,15 @@ AM62AX_IOPAD(0x130, PIN_INPUT, 0) /* (AB17) RGMII1_TXC */
AM62AX_IOPAD(0x12c, PIN_INPUT, 0) /* (W16) RGMII1_TX_CTL */
>;
};
main_mcasp1_pins_default: main-mcasp1-default-pins {
pinctrl-single,pins = <
AM62AX_IOPAD(0x090, PIN_INPUT, 2) /* (L19) GPMC0_BE0n_CLE.MCASP1_ACLKX */
AM62AX_IOPAD(0x098, PIN_INPUT, 2) /* (R18) GPMC0_WAIT0.MCASP1_AFSX */
AM62AX_IOPAD(0x08c, PIN_OUTPUT, 2) /* (K19) GPMC0_WEn.MCASP1_AXR0 */
AM62AX_IOPAD(0x084, PIN_INPUT, 2) /* (L18) GPMC0_ADVn_ALE.MCASP1_AXR2 */
>;
};
};
&mcu_pmx0 {
......@@ -377,6 +421,19 @@ exp1: gpio@22 {
"MCASP1_FET_SEL", "UART1_FET_SEL",
"PD_I2C_IRQ", "IO_EXP_TEST_LED";
};
tlv320aic3106: audio-codec@1b {
#sound-dai-cells = <0>;
compatible = "ti,tlv320aic3106";
reg = <0x1b>;
ai3x-micbias-vg = <1>; /* 2.0V */
/* Regulators */
AVDD-supply = <&vcc_3v3_sys>;
IOVDD-supply = <&vcc_3v3_sys>;
DRVDD-supply = <&vcc_3v3_sys>;
DVDD-supply = <&buck5>;
};
};
&sdhci1 {
......@@ -467,3 +524,23 @@ cpsw3g_phy0: ethernet-phy@0 {
ti,min-output-impedance;
};
};
&mcasp1 {
status = "okay";
#sound-dai-cells = <0>;
pinctrl-names = "default";
pinctrl-0 = <&main_mcasp1_pins_default>;
op-mode = <0>; /* MCASP_IIS_MODE */
tdm-slots = <2>;
serial-dir = < /* 0: INACTIVE, 1: TX, 2: RX */
1 0 2 0
0 0 0 0
0 0 0 0
0 0 0 0
>;
tx-num-evt = <32>;
rx-num-evt = <32>;
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment