drm/msm/dsi_pll_7nm: restore VCO rate during restore_state

PHY disable/enable resets PLL registers to default values. Thus in
addition to restoring several registers we also need to restore VCO rate
settings.
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Fixes: 1ef7c99d ("drm/msm/dsi: add support for 7nm DSI PHY/PLL")
Signed-off-by: Rob Clark <robdclark@chromium.org>

drivers/gpu/drm/msm/dsi/pll/dsi_pll_7nm.c

@@ -585,6 +585,7 @@ static int dsi_pll_7nm_restore_state(struct msm_dsi_pll *pll)
 	struct pll_7nm_cached_state *cached = &pll_7nm->cached_state;
 	void __iomem *phy_base = pll_7nm->phy_cmn_mmio;
 	u32 val;
+	int ret;
 
 	val = pll_read(pll_7nm->mmio + REG_DSI_7nm_PHY_PLL_PLL_OUTDIV_RATE);
 	val &= ~0x3;
@@ -599,6 +600,13 @@ static int dsi_pll_7nm_restore_state(struct msm_dsi_pll *pll)
 	val |= cached->pll_mux;
 	pll_write(phy_base + REG_DSI_7nm_PHY_CMN_CLK_CFG1, val);
 
+	ret = dsi_pll_7nm_vco_set_rate(&pll->clk_hw, pll_7nm->vco_current_rate, pll_7nm->vco_ref_clk_rate);
+	if (ret) {
+		DRM_DEV_ERROR(&pll_7nm->pdev->dev,
+			"restore vco rate failed. ret=%d\n", ret);
+		return ret;
+	}
+
 	DBG("DSI PLL%d", pll_7nm->id);
 
 	return 0;