Commit 506be3fb authored by Balaji T K's avatar Balaji T K Committed by Tony Lindgren

ARM: dts: am437x gp-evm: add sd card dt nodes

enable sd card slot on am437x-gp-evm
Signed-off-by: default avatarBalaji T K <balajitk@ti.com>
Signed-off-by: default avatarMugunthan V N <mugunthanvnm@ti.com>
Signed-off-by: default avatarTony Lindgren <tony@atomide.com>
parent 073addc8
...@@ -19,6 +19,14 @@ / { ...@@ -19,6 +19,14 @@ / {
model = "TI AM437x GP EVM"; model = "TI AM437x GP EVM";
compatible = "ti,am437x-gp-evm","ti,am4372","ti,am43"; compatible = "ti,am437x-gp-evm","ti,am4372","ti,am43";
vmmcsd_fixed: fixedregulator-sd {
compatible = "regulator-fixed";
regulator-name = "vmmcsd_fixed";
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
enable-active-high;
};
backlight { backlight {
compatible = "pwm-backlight"; compatible = "pwm-backlight";
pwms = <&ecap0 0 50000 PWM_POLARITY_INVERTED>; pwms = <&ecap0 0 50000 PWM_POLARITY_INVERTED>;
...@@ -62,6 +70,12 @@ i2c1_pins: i2c1_pins { ...@@ -62,6 +70,12 @@ i2c1_pins: i2c1_pins {
>; >;
}; };
mmc1_pins: pinmux_mmc1_pins {
pinctrl-single,pins = <
0x160 (PIN_INPUT | MUX_MODE7) /* spi0_cs1.gpio0_6 */
>;
};
ecap0_pins: backlight_pins { ecap0_pins: backlight_pins {
pinctrl-single,pins = < pinctrl-single,pins = <
0x164 MUX_MODE0 /* eCAP0_in_PWM0_out.eCAP0_in_PWM0_out MODE0 */ 0x164 MUX_MODE0 /* eCAP0_in_PWM0_out.eCAP0_in_PWM0_out MODE0 */
...@@ -91,6 +105,10 @@ &ecap0 { ...@@ -91,6 +105,10 @@ &ecap0 {
pinctrl-0 = <&ecap0_pins>; pinctrl-0 = <&ecap0_pins>;
}; };
&gpio0 {
status = "okay";
};
&gpio3 { &gpio3 {
status = "okay"; status = "okay";
}; };
...@@ -98,3 +116,12 @@ &gpio3 { ...@@ -98,3 +116,12 @@ &gpio3 {
&gpio4 { &gpio4 {
status = "okay"; status = "okay";
}; };
&mmc1 {
status = "okay";
vmmc-supply = <&vmmcsd_fixed>;
bus-width = <4>;
pinctrl-names = "default";
pinctrl-0 = <&mmc1_pins>;
cd-gpios = <&gpio0 6 GPIO_ACTIVE_HIGH>;
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment