cxl/pci: Implement wait for media active

CXL 2.0 8.1.3.8.2 states:

  Memory_Active: When set, indicates that the CXL Range 1 memory is
  fully initialized and available for software use. Must be set within
  Range 1. Memory_Active_Timeout of deassertion of reset to CXL device
  if CXL.mem HwInit Mode=1

Unfortunately, Memory_Active can take quite a long time depending on
media size (up to 256s per 2.0 spec). Provide a callback for the
eventual establishment of CXL.mem operations via the 'cxl_mem' driver
the 'struct cxl_memdev'. The implementation waits for 60s by default for
now and can be overridden by the mbox_ready_time module parameter.
Signed-off-by: Ben Widawsky <ben.widawsky@intel.com>
[djbw: switch to sleeping wait]
Reviewed-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Link: https://lore.kernel.org/r/164298427373.3018233.9309741847039301834.stgit@dwillia2-desk3.amr.corp.intel.comSigned-off-by: Dan Williams <dan.j.williams@intel.com>

drivers/cxl/cxlmem.h

@@ -132,6 +132,7 @@ struct cxl_endpoint_dvsec_info {
  * @component_reg_phys: register base of component registers
  * @info: Cached DVSEC information about the device.
  * @mbox_send: @dev specific transport for transmitting mailbox commands
+ * @wait_media_ready: @dev specific method to await media ready
  *
  * See section 8.2.9.5.2 Capacity Configuration and Label Storage for
  * details on capacity parameters.
@@ -165,6 +166,7 @@ struct cxl_dev_state {
 	struct cxl_endpoint_dvsec_info info;
 
 	int (*mbox_send)(struct cxl_dev_state *cxlds, struct cxl_mbox_cmd *cmd);
+	int (*wait_media_ready)(struct cxl_dev_state *cxlds);
 };
 
 enum cxl_opcode {

drivers/cxl/pci.c

@@ -49,7 +49,7 @@
 static unsigned short mbox_ready_timeout = 60;
 module_param(mbox_ready_timeout, ushort, 0644);
 MODULE_PARM_DESC(mbox_ready_timeout,
-		 "seconds to wait for mailbox ready status");
+		 "seconds to wait for mailbox ready / memory active status");
 
 static int cxl_pci_mbox_wait_for_doorbell(struct cxl_dev_state *cxlds)
 {
@@ -418,6 +418,51 @@ static int wait_for_valid(struct cxl_dev_state *cxlds)
 	return -ETIMEDOUT;
 }
 
+/*
+ * Wait up to @mbox_ready_timeout for the device to report memory
+ * active.
+ */
+static int wait_for_media_ready(struct cxl_dev_state *cxlds)
+{
+	struct pci_dev *pdev = to_pci_dev(cxlds->dev);
+	int d = cxlds->cxl_dvsec;
+	bool active = false;
+	u64 md_status;
+	int rc, i;
+
+	rc = wait_for_valid(cxlds);
+	if (rc)
+		return rc;
+
+	for (i = mbox_ready_timeout; i; i--) {
+		u32 temp;
+		int rc;
+
+		rc = pci_read_config_dword(
+			pdev, d + CXL_DVSEC_RANGE_SIZE_LOW(0), &temp);
+		if (rc)
+			return rc;
+
+		active = FIELD_GET(CXL_DVSEC_MEM_ACTIVE, temp);
+		if (active)
+			break;
+		msleep(1000);
+	}
+
+	if (!active) {
+		dev_err(&pdev->dev,
+			"timeout awaiting memory active after %d seconds\n",
+			mbox_ready_timeout);
+		return -ETIMEDOUT;
+	}
+
+	md_status = readq(cxlds->regs.memdev + CXLMDEV_STATUS_OFFSET);
+	if (!CXLMDEV_READY(md_status))
+		return -EIO;
+
+	return 0;
+}
+
 static int cxl_dvsec_ranges(struct cxl_dev_state *cxlds)
 {
 	struct cxl_endpoint_dvsec_info *info = &cxlds->info;
@@ -528,6 +573,8 @@ static int cxl_pci_probe(struct pci_dev *pdev, const struct pci_device_id *id)
 		dev_warn(&pdev->dev,
 			 "Device DVSEC not present, skip CXL.mem init\n");
 
+	cxlds->wait_media_ready = wait_for_media_ready;
+
 	rc = cxl_setup_regs(pdev, CXL_REGLOC_RBI_MEMDEV, &map);
 	if (rc)
 		return rc;

tools/testing/cxl/test/mem.c

@@ -4,6 +4,7 @@
 #include <linux/platform_device.h>
 #include <linux/mod_devicetable.h>
 #include <linux/module.h>
+#include <linux/delay.h>
 #include <linux/sizes.h>
 #include <linux/bits.h>
 #include <cxlmem.h>
@@ -236,6 +237,12 @@ static int cxl_mock_mbox_send(struct cxl_dev_state *cxlds, struct cxl_mbox_cmd *
 	return rc;
 }
 
+static int cxl_mock_wait_media_ready(struct cxl_dev_state *cxlds)
+{
+	msleep(100);
+	return 0;
+}
+
 static void label_area_release(void *lsa)
 {
 	vfree(lsa);
@@ -262,6 +269,7 @@ static int cxl_mock_mem_probe(struct platform_device *pdev)
 		return PTR_ERR(cxlds);
 
 	cxlds->mbox_send = cxl_mock_mbox_send;
+	cxlds->wait_media_ready = cxl_mock_wait_media_ready;
 	cxlds->payload_size = SZ_4K;
 
 	rc = cxl_enumerate_cmds(cxlds);