net: socionext: Add Synquacer NetSec driver

This driver adds support for Socionext "netsec" IP Gigabit
Ethernet + PHY IP used in the Synquacer SC2A11 SoC.
Signed-off-by: Ard Biesheuvel <ard.biesheuvel@linaro.org>
Signed-off-by: Jassi Brar <jaswinder.singh@linaro.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/socionext/Kconfig

@@ -19,4 +19,16 @@ config SNI_AVE
 	  Driver for gigabit ethernet MACs, called AVE, in the
 	  Socionext UniPhier family.
 
+config SNI_NETSEC
+	tristate "Socionext NETSEC ethernet support"
+	depends on (ARCH_SYNQUACER || COMPILE_TEST) && OF
+	select PHYLIB
+	select MII
+	---help---
+	  Enable to add support for the SocioNext NetSec Gigabit Ethernet
+	  controller + PHY, as found on the Synquacer SC2A11 SoC
+
+	  To compile this driver as a module, choose M here: the module will be
+	  called netsec.  If unsure, say N.
+
 endif #NET_VENDOR_SOCIONEXT

drivers/net/ethernet/socionext/Makefile

@@ -3,3 +3,4 @@
 # Makefile for all ethernet ip drivers on Socionext platforms
 #
 obj-$(CONFIG_SNI_AVE) += sni_ave.o
+obj-$(CONFIG_SNI_NETSEC) += netsec.o