Commit 57834ca1 authored by Stephen Hemminger's avatar Stephen Hemminger Committed by Jeff Garzik

[PATCH] chelsio: use standard CRC routines

Replace driver crc calculation with existing library.
Signed-off-by: default avatarStephen Hemminger <shemminger@osdl.org>
Signed-off-by: default avatarJeff Garzik <jeff@garzik.org>
parent a7377a50
......@@ -2360,6 +2360,7 @@ menu "Ethernet (10000 Mbit)"
config CHELSIO_T1
tristate "Chelsio 10Gb Ethernet support"
depends on PCI
select CRC32
help
This driver supports Chelsio gigabit and 10-gigabit
Ethernet cards. More information about adapter features and
......
......@@ -43,6 +43,8 @@
#include "elmer0.h"
#include "suni1x10gexp_regs.h"
#include <linux/crc32.h>
#define OFFSET(REG_ADDR) (REG_ADDR << 2)
/* Max frame size PM3393 can handle. Includes Ethernet header and CRC. */
......@@ -345,33 +347,6 @@ static int pm3393_set_mtu(struct cmac *cmac, int mtu)
return 0;
}
static u32 calc_crc(u8 *b, int len)
{
int i;
u32 crc = (u32)~0;
/* calculate crc one bit at a time */
while (len--) {
crc ^= *b++;
for (i = 0; i < 8; i++) {
if (crc & 0x1)
crc = (crc >> 1) ^ 0xedb88320;
else
crc = (crc >> 1);
}
}
/* reverse bits */
crc = ((crc >> 4) & 0x0f0f0f0f) | ((crc << 4) & 0xf0f0f0f0);
crc = ((crc >> 2) & 0x33333333) | ((crc << 2) & 0xcccccccc);
crc = ((crc >> 1) & 0x55555555) | ((crc << 1) & 0xaaaaaaaa);
/* swap bytes */
crc = (crc >> 16) | (crc << 16);
crc = (crc >> 8 & 0x00ff00ff) | (crc << 8 & 0xff00ff00);
return crc;
}
static int pm3393_set_rx_mode(struct cmac *cmac, struct t1_rx_mode *rm)
{
int enabled = cmac->instance->enabled & MAC_DIRECTION_RX;
......@@ -405,7 +380,7 @@ static int pm3393_set_rx_mode(struct cmac *cmac, struct t1_rx_mode *rm)
u16 mc_filter[4] = { 0, };
while ((addr = t1_get_next_mcaddr(rm))) {
bit = (calc_crc(addr, ETH_ALEN) >> 23) & 0x3f; /* bit[23:28] */
bit = (ether_crc(ETH_ALEN, addr) >> 23) & 0x3f; /* bit[23:28] */
mc_filter[bit >> 4] |= 1 << (bit & 0xf);
}
pmwrite(cmac, SUNI1x10GEXP_REG_RXXG_MULTICAST_HASH_LOW, mc_filter[0]);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment