Commit 582648f5 authored by Brian Masney's avatar Brian Masney Committed by Linus Walleij

arm: dts: qcom: mdm9615: add interrupt controller properties

Add interrupt controller properties now that ssbi-gpio is a proper
hierarchical IRQ chip. The interrupts property is no longer needed so
remove it.

Note that the IRQs started at 24 instead of 192 like all of the other
PMICs. This is the same IRQs as the MPP for this board. qcom-pm8xxx.c
doesn't set the shared IRQs so this is highly likely to be a copy and
paste error.
Signed-off-by: default avatarBrian Masney <masneyb@onstation.org>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
parent a796fab2
......@@ -323,13 +323,8 @@ rtc@11d {
pmicgpio: gpio@150 {
compatible = "qcom,pm8018-gpio", "qcom,ssbi-gpio";
interrupt-parent = <&pmicintc>;
interrupts = <24 IRQ_TYPE_NONE>,
<25 IRQ_TYPE_NONE>,
<26 IRQ_TYPE_NONE>,
<27 IRQ_TYPE_NONE>,
<28 IRQ_TYPE_NONE>,
<29 IRQ_TYPE_NONE>;
interrupt-controller;
#interrupt-cells = <2>;
gpio-controller;
#gpio-cells = <2>;
};
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment