Commit 5b6c273a authored by Nithin Sujir's avatar Nithin Sujir Committed by David S. Miller

tg3: Simplify tg3_phy_eee_config_ok() by reusing tg3_eee_pull_config()

eee_config_ok() was checking only for mismatch in advertised settings.
This patch expands the scope of eee_config_ok() to check for mismatch in
the other eee settings. On mismatch we will require a call to
tg3_setup_eee() to push the configured settings to the hardware.
Reviewed-by: default avatarBen Li <benli@broadcom.com>
Signed-off-by: default avatarMichael Chan <mchan@broadcom.com>
Signed-off-by: default avatarNithin Nayak Sujir <nsujir@broadcom.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 400dfbaa
......@@ -4540,26 +4540,23 @@ static int tg3_init_5401phy_dsp(struct tg3 *tp)
static bool tg3_phy_eee_config_ok(struct tg3 *tp)
{
u32 val;
u32 tgtadv = 0;
u32 advertising = tp->link_config.advertising;
struct ethtool_eee eee;
if (!(tp->phy_flags & TG3_PHYFLG_EEE_CAP))
return true;
if (tg3_phy_cl45_read(tp, MDIO_MMD_AN, MDIO_AN_EEE_ADV, &val))
return false;
val &= (MDIO_AN_EEE_ADV_100TX | MDIO_AN_EEE_ADV_1000T);
if (advertising & ADVERTISED_100baseT_Full)
tgtadv |= MDIO_AN_EEE_ADV_100TX;
if (advertising & ADVERTISED_1000baseT_Full)
tgtadv |= MDIO_AN_EEE_ADV_1000T;
tg3_eee_pull_config(tp, &eee);
if (val != tgtadv)
return false;
if (tp->eee.eee_enabled) {
if (tp->eee.advertised != eee.advertised ||
tp->eee.tx_lpi_timer != eee.tx_lpi_timer ||
tp->eee.tx_lpi_enabled != eee.tx_lpi_enabled)
return false;
} else {
/* EEE is disabled but we're advertising */
if (eee.advertised)
return false;
}
return true;
}
......@@ -4862,8 +4859,10 @@ static int tg3_setup_copper_phy(struct tg3 *tp, bool force_reset)
*/
if (!eee_config_ok &&
(tp->phy_flags & TG3_PHYFLG_KEEP_LINK_ON_PWRDN) &&
!force_reset)
!force_reset) {
tg3_setup_eee(tp);
tg3_phy_reset(tp);
}
} else {
if (!(bmcr & BMCR_ANENABLE) &&
tp->link_config.speed == current_speed &&
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment