omap3: Add external VBUS power switch and overcurrent detect onIGEP v2 board

GPIO for various devices are missing from the board initialization.
This patch adds support for the VBUS and over current gpios.  Without this
patch, input/outputs from these two sources are ignored.
Signed-off-by: Enric Balletbo i Serra <eballetbo@gmail.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

arch/arm/mach-omap2/board-igep0020.c

@@ -275,6 +275,22 @@ static int igep2_twl_gpio_setup(struct device *dev,
 	igep2_vmmc1_supply.dev = mmc[0].dev;
 	igep2_vmmc2_supply.dev = mmc[1].dev;
 
+	/*
+	 * REVISIT: need ehci-omap hooks for external VBUS
+	 * power switch and overcurrent detect
+	 */
+	if ((gpio_request(gpio + 1, "GPIO_EHCI_NOC") < 0) ||
+	    (gpio_direction_input(gpio + 1) < 0))
+		pr_err("IGEP2: Could not obtain gpio for EHCI NOC");
+
+	/*
+	 * TWL4030_GPIO_MAX + 0 == ledA, GPIO_USBH_CPEN
+	 * (out, active low)
+	 */
+	if ((gpio_request(gpio + TWL4030_GPIO_MAX, "GPIO_USBH_CPEN") < 0) ||
+	    (gpio_direction_output(gpio + TWL4030_GPIO_MAX, 0) < 0))
+		pr_err("IGEP2: Could not obtain gpio for USBH_CPEN");
+
 	return 0;
 };