wl1251: fix oops on early interrupt

commit f380f2c4 upstream.

This driver disables interrupt just after requesting it and enables it
later, after interface is up. However currently there is a time window
between request_irq() and disable_irq() where if interrupt arrives, the
driver oopses because it's not yet ready to process it. This can be
reproduced by inserting the module, associating and removing the module
multiple times.

Eliminate this race by setting IRQF_NOAUTOEN flag before request_irq().
Signed-off-by: Grazvydas Ignotas <notasas@gmail.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/net/wireless/wl1251/sdio.c

@@ -259,6 +259,7 @@ static int wl1251_sdio_probe(struct sdio_func *func,
 	}
 
 	if (wl->irq) {
+		irq_set_status_flags(wl->irq, IRQ_NOAUTOEN);
 		ret = request_irq(wl->irq, wl1251_line_irq, 0, "wl1251", wl);
 		if (ret < 0) {
 			wl1251_error("request_irq() failed: %d", ret);
@@ -266,7 +267,6 @@ static int wl1251_sdio_probe(struct sdio_func *func,
 		}
 
 		irq_set_irq_type(wl->irq, IRQ_TYPE_EDGE_RISING);
-		disable_irq(wl->irq);
 
 		wl1251_sdio_ops.enable_irq = wl1251_enable_line_irq;
 		wl1251_sdio_ops.disable_irq = wl1251_disable_line_irq;

drivers/net/wireless/wl1251/spi.c

@@ -280,6 +280,7 @@ static int __devinit wl1251_spi_probe(struct spi_device *spi)
 
 	wl->use_eeprom = pdata->use_eeprom;
 
+	irq_set_status_flags(wl->irq, IRQ_NOAUTOEN);
 	ret = request_irq(wl->irq, wl1251_irq, 0, DRIVER_NAME, wl);
 	if (ret < 0) {
 		wl1251_error("request_irq() failed: %d", ret);
@@ -288,8 +289,6 @@ static int __devinit wl1251_spi_probe(struct spi_device *spi)
 
 	irq_set_irq_type(wl->irq, IRQ_TYPE_EDGE_RISING);
 
-	disable_irq(wl->irq);
-
 	ret = wl1251_init_ieee80211(wl);
 	if (ret)
 		goto out_irq;