net: qca_7k: Use BIT macro

Use the BIT macro for the CONFIG and INT register values.
Signed-off-by: Stefan Wahren <stefan.wahren@i2se.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/qualcomm/qca_7k.h

@@ -54,15 +54,15 @@
 #define SPI_REG_ACTION_CTRL     0x1B00
 
 /*   SPI_CONFIG register definition;             */
-#define QCASPI_SLAVE_RESET_BIT (1 << 6)
+#define QCASPI_SLAVE_RESET_BIT  BIT(6)
 
 /*   INTR_CAUSE/ENABLE register definition.      */
-#define SPI_INT_WRBUF_BELOW_WM (1 << 10)
-#define SPI_INT_CPU_ON         (1 << 6)
-#define SPI_INT_ADDR_ERR       (1 << 3)
-#define SPI_INT_WRBUF_ERR      (1 << 2)
-#define SPI_INT_RDBUF_ERR      (1 << 1)
-#define SPI_INT_PKT_AVLBL      (1 << 0)
+#define SPI_INT_WRBUF_BELOW_WM  BIT(10)
+#define SPI_INT_CPU_ON          BIT(6)
+#define SPI_INT_ADDR_ERR        BIT(3)
+#define SPI_INT_WRBUF_ERR       BIT(2)
+#define SPI_INT_RDBUF_ERR       BIT(1)
+#define SPI_INT_PKT_AVLBL       BIT(0)
 
 void qcaspi_spi_error(struct qcaspi *qca);
 int qcaspi_read_register(struct qcaspi *qca, u16 reg, u16 *result);