net: phy: aquantia: rename and export aqr107_wait_reset_complete()

This function is quite generic in this driver and not limited to aqr107.
We will use it outside its current compilation unit soon so rename it
and declare it in the header.
Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@linaro.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/phy/aquantia/aquantia.h

@@ -201,4 +201,6 @@ int aqr_phy_led_hw_control_set(struct phy_device *phydev, u8 index,
 int aqr_phy_led_active_low_set(struct phy_device *phydev, int index, bool enable);
 int aqr_phy_led_polarity_set(struct phy_device *phydev, int index,
 			     unsigned long modes);
+int aqr_wait_reset_complete(struct phy_device *phydev);
+
 #endif /* AQUANTIA_H */

drivers/net/phy/aquantia/aquantia_main.c

@@ -441,7 +441,7 @@ static int aqr107_set_tunable(struct phy_device *phydev,
  * The chip also provides a "reset completed" bit, but it's cleared after
  * read. Therefore function would time out if called again.
  */
-static int aqr107_wait_reset_complete(struct phy_device *phydev)
+int aqr_wait_reset_complete(struct phy_device *phydev)
 {
 	int val;
 
@@ -494,7 +494,7 @@ static int aqr107_config_init(struct phy_device *phydev)
 	WARN(phydev->interface == PHY_INTERFACE_MODE_XGMII,
 	     "Your devicetree is out of date, please update it. The AQR107 family doesn't support XGMII, maybe you mean USXGMII.\n");
 
-	ret = aqr107_wait_reset_complete(phydev);
+	ret = aqr_wait_reset_complete(phydev);
 	if (!ret)
 		aqr107_chip_info(phydev);
 
@@ -522,7 +522,7 @@ static int aqcs109_config_init(struct phy_device *phydev)
 	    phydev->interface != PHY_INTERFACE_MODE_2500BASEX)
 		return -ENODEV;
 
-	ret = aqr107_wait_reset_complete(phydev);
+	ret = aqr_wait_reset_complete(phydev);
 	if (!ret)
 		aqr107_chip_info(phydev);