Commit 664e9e49 authored by Fabio Estevam's avatar Fabio Estevam Committed by Shawn Guo

ARM: dts: imx23-olinuxino: Fix IOMUX settings

On the imx23-olinuxino board GPIO2_1 is connected to the LED and GPIO0_17
is the USB PHY reset.

So make the IOMUX assignment properly.
Signed-off-by: default avatarFabio Estevam <fabio.estevam@freescale.com>
Signed-off-by: default avatarShawn Guo <shawn.guo@linaro.org>
parent a49f0d1e
...@@ -39,17 +39,17 @@ pinctrl@80018000 { ...@@ -39,17 +39,17 @@ pinctrl@80018000 {
hog_pins_a: hog@0 { hog_pins_a: hog@0 {
reg = <0>; reg = <0>;
fsl,pinmux-ids = < fsl,pinmux-ids = <
0x2013 /* MX23_PAD_SSP1_DETECT__GPIO_2_1 */ 0x0113 /* MX23_PAD_GPMI_ALE__GPIO_0_17 */
>; >;
fsl,drive-strength = <0>; fsl,drive-strength = <0>;
fsl,voltage = <1>; fsl,voltage = <1>;
fsl,pull-up = <0>; fsl,pull-up = <0>;
}; };
led_pin_gpio0_17: led_gpio0_17@0 { led_pin_gpio2_1: led_gpio2_1@0 {
reg = <0>; reg = <0>;
fsl,pinmux-ids = < fsl,pinmux-ids = <
0x0113 /* MX23_PAD_GPMI_ALE__GPIO_0_17 */ 0x2013 /* MX23_PAD_SSP1_DETECT__GPIO_2_1 */
>; >;
fsl,drive-strength = <0>; fsl,drive-strength = <0>;
fsl,voltage = <1>; fsl,voltage = <1>;
...@@ -110,7 +110,7 @@ reg_usb0_vbus: usb0_vbus { ...@@ -110,7 +110,7 @@ reg_usb0_vbus: usb0_vbus {
leds { leds {
compatible = "gpio-leds"; compatible = "gpio-leds";
pinctrl-names = "default"; pinctrl-names = "default";
pinctrl-0 = <&led_pin_gpio0_17>; pinctrl-0 = <&led_pin_gpio2_1>;
user { user {
label = "green"; label = "green";
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment