md: be more careful setting MD_CHANGE_CLEAN

When MD_CHANGE_CLEAN is set we might block in md_write_start.
So we should only set it when fairly sure that something will clear
it.

There are two places where it is set so as to encourage a metadata
update to record the progress of resync/recovery.  This should only
be done if the internal metadata update mechanisms are in use, which
can be tested by by inspecting '->persistent'.
Signed-off-by: NeilBrown <neilb@suse.de>

drivers/md/bitmap.c

@@ -1526,7 +1526,8 @@ void bitmap_cond_end_sync(struct bitmap *bitmap, sector_t sector)
 		   atomic_read(&bitmap->mddev->recovery_active) == 0);
 
 	bitmap->mddev->curr_resync_completed = bitmap->mddev->curr_resync;
-	set_bit(MD_CHANGE_CLEAN, &bitmap->mddev->flags);
+	if (bitmap->mddev->persistent)
+		set_bit(MD_CHANGE_CLEAN, &bitmap->mddev->flags);
 	sector &= ~((1ULL << CHUNK_BLOCK_SHIFT(bitmap)) - 1);
 	s = 0;
 	while (s < sector && s < bitmap->mddev->resync_max_sectors) {

drivers/md/md.c

@@ -6753,7 +6753,8 @@ void md_do_sync(mddev_t *mddev)
 				   atomic_read(&mddev->recovery_active) == 0);
 			mddev->curr_resync_completed =
 				mddev->curr_resync;
-			set_bit(MD_CHANGE_CLEAN, &mddev->flags);
+			if (mddev->persistent)
+				set_bit(MD_CHANGE_CLEAN, &mddev->flags);
 			sysfs_notify(&mddev->kobj, NULL, "sync_completed");
 		}