Commit 694440d9 authored by Eliad Peller's avatar Eliad Peller Committed by Luciano Coelho

wl12xx: disable AP-mode-specific quirks

The current wl12xx fw (7.3.0.0.77) supports both STA and AP mode, and
we no longer use AP-mode-specific quirks.

WL12XX_QUIRK_END_OF_TRANSACTION is still used for certain HWs, while
WL12XX_QUIRK_LPD_MODE is not used anymore.
Signed-off-by: default avatarEliad Peller <eliad@wizery.com>
Signed-off-by: default avatarLuciano Coelho <coelho@ti.com>
parent 6d158ff3
...@@ -770,9 +770,6 @@ int wl1271_load_firmware(struct wl1271 *wl) ...@@ -770,9 +770,6 @@ int wl1271_load_firmware(struct wl1271 *wl)
clk |= (wl->ref_clock << 1) << 4; clk |= (wl->ref_clock << 1) << 4;
} }
if (wl->quirks & WL12XX_QUIRK_LPD_MODE)
clk |= SCRATCH_ENABLE_LPD;
wl1271_write32(wl, DRPW_SCRATCH_START, clk); wl1271_write32(wl, DRPW_SCRATCH_START, clk);
wl1271_set_partition(wl, &part_table[PART_WORK]); wl1271_set_partition(wl, &part_table[PART_WORK]);
......
...@@ -134,11 +134,6 @@ int wl1271_cmd_general_parms(struct wl1271 *wl) ...@@ -134,11 +134,6 @@ int wl1271_cmd_general_parms(struct wl1271 *wl)
/* Override the REF CLK from the NVS with the one from platform data */ /* Override the REF CLK from the NVS with the one from platform data */
gen_parms->general_params.ref_clock = wl->ref_clock; gen_parms->general_params.ref_clock = wl->ref_clock;
/* LPD mode enable (bits 6-7) in WL1271 AP mode only */
if (wl->quirks & WL12XX_QUIRK_LPD_MODE)
gen_parms->general_params.general_settings |=
GENERAL_SETTINGS_DRPW_LPD;
ret = wl1271_cmd_test(wl, gen_parms, sizeof(*gen_parms), answer); ret = wl1271_cmd_test(wl, gen_parms, sizeof(*gen_parms), answer);
if (ret < 0) { if (ret < 0) {
wl1271_warning("CMD_INI_FILE_GENERAL_PARAM failed"); wl1271_warning("CMD_INI_FILE_GENERAL_PARAM failed");
......
...@@ -1333,14 +1333,6 @@ static int wl1271_chip_wakeup(struct wl1271 *wl) ...@@ -1333,14 +1333,6 @@ static int wl1271_chip_wakeup(struct wl1271 *wl)
wl1271_debug(DEBUG_BOOT, "chip id 0x%x (1271 PG20)", wl1271_debug(DEBUG_BOOT, "chip id 0x%x (1271 PG20)",
wl->chip.id); wl->chip.id);
/*
* 'end-of-transaction flag' and 'LPD mode flag'
* should be set in wl127x AP mode only
*/
if (wl->bss_type == BSS_TYPE_AP_BSS)
wl->quirks |= (WL12XX_QUIRK_END_OF_TRANSACTION |
WL12XX_QUIRK_LPD_MODE);
ret = wl1271_setup(wl); ret = wl1271_setup(wl);
if (ret < 0) if (ret < 0)
goto out; goto out;
......
...@@ -672,12 +672,6 @@ size_t wl12xx_copy_fwlog(struct wl1271 *wl, u8 *memblock, size_t maxlen); ...@@ -672,12 +672,6 @@ size_t wl12xx_copy_fwlog(struct wl1271 *wl, u8 *memblock, size_t maxlen);
/* WL128X requires aggregated packets to be aligned to the SDIO block size */ /* WL128X requires aggregated packets to be aligned to the SDIO block size */
#define WL12XX_QUIRK_BLOCKSIZE_ALIGNMENT BIT(2) #define WL12XX_QUIRK_BLOCKSIZE_ALIGNMENT BIT(2)
/*
* WL127X AP mode requires Low Power DRPw (LPD) enable to reduce power
* consumption
*/
#define WL12XX_QUIRK_LPD_MODE BIT(3)
/* Older firmwares did not implement the FW logger over bus feature */ /* Older firmwares did not implement the FW logger over bus feature */
#define WL12XX_QUIRK_FWLOG_NOT_IMPLEMENTED BIT(4) #define WL12XX_QUIRK_FWLOG_NOT_IMPLEMENTED BIT(4)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment