Commit 69646d7a authored by Razvan Stefanescu's avatar Razvan Stefanescu Committed by Greg Kroah-Hartman

tty/serial: atmel: RS485 HD w/DMA: enable RX after TX is stopped

In half-duplex operation, RX should be started after TX completes.

If DMA is used, there is a case when the DMA transfer completes but the
TX FIFO is not emptied, so the RX cannot be restarted just yet.

Use a boolean variable to store this state and rearm TX interrupt mask
to be signaled again that the transfer finished. In interrupt transmit
handler this variable is used to start RX. A warning message is generated
if RX is activated before TX fifo is cleared.

Fixes: b389f173 ("tty/serial: atmel: RS485 half duplex w/DMA: enable
RX after TX is done")
Signed-off-by: default avatarRazvan Stefanescu <razvan.stefanescu@microchip.com>
Acked-by: default avatarRichard Genoud <richard.genoud@gmail.com>
Cc: stable <stable@vger.kernel.org>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent f3040983
......@@ -166,6 +166,8 @@ struct atmel_uart_port {
unsigned int pending_status;
spinlock_t lock_suspended;
bool hd_start_rx; /* can start RX during half-duplex operation */
/* ISO7816 */
unsigned int fidi_min;
unsigned int fidi_max;
......@@ -933,8 +935,13 @@ static void atmel_complete_tx_dma(void *arg)
if (!uart_circ_empty(xmit))
atmel_tasklet_schedule(atmel_port, &atmel_port->tasklet_tx);
else if (atmel_uart_is_half_duplex(port)) {
/* DMA done, stop TX, start RX for RS485 */
atmel_start_rx(port);
/*
* DMA done, re-enable TXEMPTY and signal that we can stop
* TX and start RX for RS485
*/
atmel_port->hd_start_rx = true;
atmel_uart_writel(port, ATMEL_US_IER,
atmel_port->tx_done_mask);
}
spin_unlock_irqrestore(&port->lock, flags);
......@@ -1382,9 +1389,20 @@ atmel_handle_transmit(struct uart_port *port, unsigned int pending)
struct atmel_uart_port *atmel_port = to_atmel_uart_port(port);
if (pending & atmel_port->tx_done_mask) {
/* Either PDC or interrupt transmission */
atmel_uart_writel(port, ATMEL_US_IDR,
atmel_port->tx_done_mask);
/* Start RX if flag was set and FIFO is empty */
if (atmel_port->hd_start_rx) {
if (!(atmel_uart_readl(port, ATMEL_US_CSR)
& ATMEL_US_TXEMPTY))
dev_warn(port->dev, "Should start RX, but TX fifo is not empty\n");
atmel_port->hd_start_rx = false;
atmel_start_rx(port);
return;
}
atmel_tasklet_schedule(atmel_port, &atmel_port->tasklet_tx);
}
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment