Commit 6a690df5 authored by Hannes Reinecke's avatar Hannes Reinecke Committed by Jeff Garzik

[PATCH] scan all enabled ports on ata_piix

ICH6 spec defines the PORT_ bits as:

PORT_ENABLED (R/W):

  0 = Disabled.  The port is in the off state and cannot detect any
  devices.

  1 = Enabled.  The port can transition between the on, partial, and
  slumber states and can detect devices.

PORT_PRESENT  (R/O)

  The status of this bit may change at any time.  This bit is cleared
  when the port is disabled via PORT_ENABLED.  This bit is not cleared upon
  surprise removal of a device.

So from a textual view it is not necessary that PORT_PRESENT _must_ be set,
especially if a device detection has to be done anyway.  And, in fact, this
is the view that ACER has been taken with its new Laptops (e.g.  Travelmate
4150).

And the definition of PORT_ENABLED / PORT_PRESENT is mixed up, btw.
Signed-off-by: default avatarHannes Reinecke <hare@suse.de>
Signed-off-by: default avatarJens Axboe <axboe@suse.de>
Cc: Jeff Garzik <jgarzik@pobox.com>
Signed-off-by: default avatarAndrew Morton <akpm@osdl.org>
Signed-off-by: default avatarJeff Garzik <jgarzik@pobox.com>
parent 5a2cec83
......@@ -68,8 +68,8 @@ enum {
PIIX_COMB_PATA_P0 = (1 << 1),
PIIX_COMB = (1 << 2), /* combined mode enabled? */
PIIX_PORT_PRESENT = (1 << 0),
PIIX_PORT_ENABLED = (1 << 4),
PIIX_PORT_ENABLED = (1 << 0),
PIIX_PORT_PRESENT = (1 << 4),
PIIX_80C_PRI = (1 << 5) | (1 << 4),
PIIX_80C_SEC = (1 << 7) | (1 << 6),
......@@ -377,7 +377,9 @@ static void piix_pata_phy_reset(struct ata_port *ap)
* None (inherited from caller).
*
* RETURNS:
* Non-zero if device detected, zero otherwise.
* Non-zero if port is enabled, it may or may not have a device
* attached in that case (PRESENT bit would only be set if BIOS probe
* was done). Zero is returned if port is disabled.
*/
static int piix_sata_probe (struct ata_port *ap)
{
......@@ -401,7 +403,7 @@ static int piix_sata_probe (struct ata_port *ap)
*/
for (i = 0; i < 4; i++) {
mask = (PIIX_PORT_PRESENT << i) | (PIIX_PORT_ENABLED << i);
mask = (PIIX_PORT_ENABLED << i);
if ((orig_mask & mask) == mask)
if (combined || (i == ap->hard_port_no))
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment