ARM: zynq: use physical cpuid in zynq_slcr_cpu_stop/start

When kernel booting, it will create a cpuid map between the logical cpus
and physical cpus. In a normal boot, the cpuid map is as below:

    Physical      Logical
        0    ==>     0
        1    ==>     1

But in kdump, there is a condition that the crash happens at the
physical cpu1, and the crash kernel will run at the physical cpu1 too,
so the cpuid map in crash kernel is as below:

    Physical      Logical
        1    ==>     0
        0    ==>     1

The functions zynq_slcr_cpu_stop/start is to stop/start the physical
cpus, the parameter cpu should be the physical cpuid. So use
cpu_logical_map to translate the logical cpuid to physical cpuid.
Or else the logical cpu0(physical cpu1) will stop itself and
the processor will hang.
Signed-off-by: Quanyang Wang <quanyang.wang@windriver.com>
Tested-by: Michal Simek <michal.simek@xilinx.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>

arch/arm/mach-zynq/platsmp.c

@@ -15,6 +15,7 @@
 #include <linux/init.h>
 #include <linux/io.h>
 #include <asm/cacheflush.h>
+#include <asm/smp_plat.h>
 #include <asm/smp_scu.h>
 #include <linux/irqchip/arm-gic.h>
 #include "common.h"
@@ -30,6 +31,7 @@ int zynq_cpun_start(u32 address, int cpu)
 {
 	u32 trampoline_code_size = &zynq_secondary_trampoline_end -
 						&zynq_secondary_trampoline;
+	u32 phy_cpuid = cpu_logical_map(cpu);
 
 	/* MS: Expectation that SLCR are directly map and accessible */
 	/* Not possible to jump to non aligned address */
@@ -39,7 +41,7 @@ int zynq_cpun_start(u32 address, int cpu)
 		u32 trampoline_size = &zynq_secondary_trampoline_jump -
 						&zynq_secondary_trampoline;
 
-		zynq_slcr_cpu_stop(cpu);
+		zynq_slcr_cpu_stop(phy_cpuid);
 		if (address) {
 			if (__pa(PAGE_OFFSET)) {
 				zero = ioremap(0, trampoline_code_size);
@@ -68,7 +70,7 @@ int zynq_cpun_start(u32 address, int cpu)
 			if (__pa(PAGE_OFFSET))
 				iounmap(zero);
 		}
-		zynq_slcr_cpu_start(cpu);
+		zynq_slcr_cpu_start(phy_cpuid);
 
 		return 0;
 	}