Merge tag 'soc-fixes-6.9-3' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

Pull ARM SoC fixes from Arnd Bergmann:
 "These are a couple of last minute fixes that came in over the previous
  week, addressing:

   - A pin configuration bug on a qualcomm board that caused issues with
     ethernet and mmc

   - Two minor code fixes for misleading console output in the microchip
     firmware driver

   - A build warning in the sifive cache driver"

* tag 'soc-fixes-6.9-3' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc:
  firmware: microchip: clarify that sizes and addresses are in hex
  firmware: microchip: don't unconditionally print validation success
  arm64: dts: qcom: sa8155p-adp: fix SDHC2 CD pin configuration
  cache: sifive_ccache: Silence unused variable warning

arch/arm64/boot/dts/qcom/sa8155p-adp.dts

@@ -367,6 +367,16 @@ queue0 {
 	};
 };
 
+&pmm8155au_1_gpios {
+	pmm8155au_1_sdc2_cd: sdc2-cd-default-state {
+		pins = "gpio4";
+		function = "normal";
+		input-enable;
+		bias-pull-up;
+		power-source = <0>;
+	};
+};
+
 &qupv3_id_1 {
 	status = "okay";
 };
@@ -384,10 +394,10 @@ &remoteproc_cdsp {
 &sdhc_2 {
 	status = "okay";
 
-	cd-gpios = <&tlmm 4 GPIO_ACTIVE_LOW>;
+	cd-gpios = <&pmm8155au_1_gpios 4 GPIO_ACTIVE_LOW>;
 	pinctrl-names = "default", "sleep";
-	pinctrl-0 = <&sdc2_on>;
-	pinctrl-1 = <&sdc2_off>;
+	pinctrl-0 = <&sdc2_on &pmm8155au_1_sdc2_cd>;
+	pinctrl-1 = <&sdc2_off &pmm8155au_1_sdc2_cd>;
 	vqmmc-supply = <&vreg_l13c_2p96>; /* IO line power */
 	vmmc-supply = <&vreg_l17a_2p96>;  /* Card power line */
 	bus-width = <4>;
@@ -505,13 +515,6 @@ data-pins {
 			bias-pull-up;		/* pull up */
 			drive-strength = <16>;	/* 16 MA */
 		};
-
-		sd-cd-pins {
-			pins = "gpio96";
-			function = "gpio";
-			bias-pull-up;		/* pull up */
-			drive-strength = <2>;	/* 2 MA */
-		};
 	};
 
 	sdc2_off: sdc2-off-state {
@@ -532,13 +535,6 @@ data-pins {
 			bias-pull-up;		/* pull up */
 			drive-strength = <2>;	/* 2 MA */
 		};
-
-		sd-cd-pins {
-			pins = "gpio96";
-			function = "gpio";
-			bias-pull-up;		/* pull up */
-			drive-strength = <2>;	/* 2 MA */
-		};
 	};
 
 	usb2phy_ac_en1_default: usb2phy-ac-en1-default-state {

drivers/cache/sifive_ccache.c

@@ -290,7 +290,7 @@ static int __init sifive_ccache_init(void)
 	struct device_node *np;
 	struct resource res;
 	const struct of_device_id *match;
-	unsigned long quirks;
+	unsigned long quirks __maybe_unused;
 	int rc;
 
 	np = of_find_matching_node_and_match(NULL, sifive_ccache_ids, &match);

drivers/firmware/microchip/mpfs-auto-update.c

@@ -206,10 +206,12 @@ static int mpfs_auto_update_verify_image(struct fw_upload *fw_uploader)
 	if (ret | response->resp_status) {
 		dev_warn(priv->dev, "Verification of Upgrade Image failed!\n");
 		ret = ret ? ret : -EBADMSG;
+		goto free_message;
 	}
 
 	dev_info(priv->dev, "Verification of Upgrade Image passed!\n");
 
+free_message:
 	devm_kfree(priv->dev, message);
 free_response:
 	devm_kfree(priv->dev, response);
@@ -265,7 +267,7 @@ static int mpfs_auto_update_set_image_address(struct mpfs_auto_update_priv *priv
 	       AUTO_UPDATE_DIRECTORY_WIDTH);
 	memset(buffer + AUTO_UPDATE_BLANK_DIRECTORY, 0x0, AUTO_UPDATE_DIRECTORY_WIDTH);
 
-	dev_info(priv->dev, "Writing the image address (%x) to the flash directory (%llx)\n",
+	dev_info(priv->dev, "Writing the image address (0x%x) to the flash directory (0x%llx)\n",
 		 image_address, directory_address);
 
 	ret = mtd_write(priv->flash, 0x0, erase_size, &bytes_written, (u_char *)buffer);
@@ -313,7 +315,7 @@ static int mpfs_auto_update_write_bitstream(struct fw_upload *fw_uploader, const
 	erase.len = round_up(size, (size_t)priv->flash->erasesize);
 	erase.addr = image_address;
 
-	dev_info(priv->dev, "Erasing the flash at address (%x)\n", image_address);
+	dev_info(priv->dev, "Erasing the flash at address (0x%x)\n", image_address);
 	ret = mtd_erase(priv->flash, &erase);
 	if (ret)
 		goto out;
@@ -323,7 +325,7 @@ static int mpfs_auto_update_write_bitstream(struct fw_upload *fw_uploader, const
 	 * will do all of that itself - including verifying that the bitstream
 	 * is valid.
 	 */
-	dev_info(priv->dev, "Writing the image to the flash at address (%x)\n", image_address);
+	dev_info(priv->dev, "Writing the image to the flash at address (0x%x)\n", image_address);
 	ret = mtd_write(priv->flash, (loff_t)image_address, size, &bytes_written, data);
 	if (ret)
 		goto out;