Commit 6f4728c5 authored by Ben Dooks's avatar Ben Dooks Committed by Nicolas Ferre

ARM: at91/dt: sama5d3 xplained: fill in mmc1 and set it to disabled

The mmc1 channel is not populated on the SAM5D3 Xplained board, however
it is enabled and therefore the driver is attaching to it.

The node configuration for mmc1 is missing, so add an mmc1 node in the
device tree and set its status to disabled. Also add the vmmc and the
necessary slot configuration if this node were enabled to avoid the following
warnings from the driver:

atmel_mci f8000000.mmc: No vmmc regulator found
atmel_mci f8000000.mmc: No vqmmc regulator found
Signed-off-by: default avatarBen Dooks <ben.dooks@codethink.co.uk>
Signed-off-by: default avatarLudovic Desroches <ludovic.desroches@atmel.com>
Signed-off-by: default avatarNicolas Ferre <nicolas.ferre@atmel.com>
parent 55d6cbaa
...@@ -43,6 +43,17 @@ slot@0 { ...@@ -43,6 +43,17 @@ slot@0 {
}; };
}; };
mmc1: mmc@f8000000 {
vmmc-supply = <&vcc_3v3_reg>;
vqmmc-supply = <&vcc_3v3_reg>;
status = "disabled";
slot@0 {
reg = <0>;
bus-width = <4>;
cd-gpios = <&pioE 1 GPIO_ACTIVE_LOW>;
};
};
spi0: spi@f0004000 { spi0: spi@f0004000 {
cs-gpios = <&pioD 13 0>, <0>, <0>, <&pioD 16 0>; cs-gpios = <&pioD 13 0>, <0>, <0>, <&pioD 16 0>;
status = "okay"; status = "okay";
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment