ARM: imx: remove cpu_is_mx1 check

There is only one call site for this, and it's easily replaced
by initializing the reset value at boot time.
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

arch/arm/mach-imx/common.h

@@ -54,6 +54,7 @@ struct platform_device *mxc_register_gpio(char *name, int id,
 void mxc_set_cpu_type(unsigned int type);
 void mxc_restart(enum reboot_mode, const char *);
 void mxc_arch_reset_init(void __iomem *);
+void imx1_reset_init(void __iomem *);
 void imx_set_aips(void __iomem *);
 void imx_aips_allow_unprivileged_access(const char *compat);
 int mxc_device_init(void);

arch/arm/mach-imx/mm-imx1.c

@@ -50,7 +50,7 @@ void __init mx1_init_irq(void)
 
 void __init imx1_soc_init(void)
 {
-	mxc_arch_reset_init(MX1_IO_ADDRESS(MX1_WDT_BASE_ADDR));
+	imx1_reset_init(MX1_IO_ADDRESS(MX1_WDT_BASE_ADDR));
 	mxc_device_init();
 
 	mxc_register_gpio("imx1-gpio", 0, MX1_GPIO1_BASE_ADDR, SZ_256,

arch/arm/mach-imx/system.c

@@ -34,25 +34,19 @@
 
 static void __iomem *wdog_base;
 static struct clk *wdog_clk;
+static int wcr_enable = (1 << 2);
 
 /*
  * Reset the system. It is called by machine_restart().
  */
 void mxc_restart(enum reboot_mode mode, const char *cmd)
 {
-	unsigned int wcr_enable;
-
 	if (!wdog_base)
 		goto reset_fallback;
 
 	if (!IS_ERR(wdog_clk))
 		clk_enable(wdog_clk);
 
-	if (cpu_is_mx1())
-		wcr_enable = (1 << 0);
-	else
-		wcr_enable = (1 << 2);
-
 	/* Assert SRS signal */
 	imx_writew(wcr_enable, wdog_base);
 	/*
@@ -89,6 +83,14 @@ void __init mxc_arch_reset_init(void __iomem *base)
 		clk_prepare(wdog_clk);
 }
 
+#ifdef CONFIG_SOC_IMX1
+void __init imx1_reset_init(void __iomem *base)
+{
+	wcr_enable = (1 << 0);
+	mxc_arch_reset_init(base);
+}
+#endif
+
 #ifdef CONFIG_CACHE_L2X0
 void __init imx_init_l2cache(void)
 {