ALSA: emu10k1: fix snd_emu1010_fpga_read() input masking for rev2 cards

Unlike the Alice2 chips used on 1st generation E-MU cards, the
Tina/Tina2 chips used on the 2nd gen cards have only six GPIN pins,
which means that we need to use a smaller mask. Failure to do so would
falsify the read data if the FPGA tried to raise an IRQ right at that
moment. This wasn't a problem so far, as we didn't actually enable FPGA
IRQs, but that's going to change soon.
Signed-off-by: Oswald Buddenhagen <oswald.buddenhagen@gmx.de>
Link: https://lore.kernel.org/r/20230422132430.1057490-1-oswald.buddenhagen@gmx.deSigned-off-by: Takashi Iwai <tiwai@suse.de>

include/sound/emu10k1.h

@@ -252,7 +252,8 @@
 #define MUSTAT_ORDYN		0x40		/* 0 = MUDATA can accept a command or data	*/
 
 #define A_GPIO			0x18		/* GPIO on Audigy card (16bits)			*/
-#define A_GPINPUT_MASK		0xff00
+#define A_GPINPUT_MASK		0xff00		/* Alice/2 has 8 input pins			*/
+#define A3_GPINPUT_MASK		0x3f00		/* ... while Tina/2 has only 6			*/
 #define A_GPOUTPUT_MASK		0x00ff
 
 // The GPIO port is used for I/O config on Sound Blasters;

sound/pci/emu10k1/io.c

@@ -255,6 +255,9 @@ void snd_emu1010_fpga_write(struct snd_emu10k1 *emu, u32 reg, u32 value)
 
 void snd_emu1010_fpga_read(struct snd_emu10k1 *emu, u32 reg, u32 *value)
 {
+	// The higest input pin is used as the designated interrupt trigger,
+	// so it needs to be masked out.
+	u32 mask = emu->card_capabilities->ca0108_chip ? 0x1f : 0x7f;
 	unsigned long flags;
 	if (snd_BUG_ON(reg > 0x3f))
 		return;
@@ -264,7 +267,7 @@ void snd_emu1010_fpga_read(struct snd_emu10k1 *emu, u32 reg, u32 *value)
 	udelay(10);
 	outw(reg | 0x80, emu->port + A_GPIO);  /* High bit clocks the value into the fpga. */
 	udelay(10);
-	*value = ((inw(emu->port + A_GPIO) >> 8) & 0x7f);
+	*value = ((inw(emu->port + A_GPIO) >> 8) & mask);
 	spin_unlock_irqrestore(&emu->emu_lock, flags);
 }