i2c: iop3xx: use standard gpiolib functions

Instead of using the custom iop3xx gpio functions, use the gpiolib
variants. This should be functionally the same since the gpiolib
just calls the iop3xx gpio functions. This is needed in preparation
of removing iop3xx mach/io.h headers.
Signed-off-by: Rob Herring <rob.herring@calxeda.com>
Cc: "Jean Delvare (PC drivers, core)" <khali@linux-fr.org>
Cc: "Ben Dooks (embedded platforms)" <ben-linux@fluff.org>
Cc: "Wolfram Sang (embedded platforms)" <w.sang@pengutronix.de>
Cc: linux-i2c@vger.kernel.org

drivers/i2c/busses/i2c-iop3xx.c

@@ -39,6 +39,7 @@
 #include <linux/platform_device.h>
 #include <linux/i2c.h>
 #include <linux/io.h>
+#include <linux/gpio.h>
 
 #include "i2c-iop3xx.h"
 
@@ -78,11 +79,11 @@ iop3xx_i2c_enable(struct i2c_algo_iop3xx_data *iop3xx_adap)
 	 */
 #if defined(CONFIG_ARCH_IOP32X) || defined(CONFIG_ARCH_IOP33X)
 	if (iop3xx_adap->id == 0) {
-		gpio_line_set(IOP3XX_GPIO_LINE(7), GPIO_LOW);
-		gpio_line_set(IOP3XX_GPIO_LINE(6), GPIO_LOW);
+		gpio_set_value(7, 0);
+		gpio_set_value(6, 0);
 	} else {
-		gpio_line_set(IOP3XX_GPIO_LINE(5), GPIO_LOW);
-		gpio_line_set(IOP3XX_GPIO_LINE(4), GPIO_LOW);
+		gpio_set_value(5, 0);
+		gpio_set_value(4, 0);
 	}
 #endif
 	/* NB SR bits not same position as CR IE bits :-( */