Commit 707d80f0 authored by Jules Maselbas's avatar Jules Maselbas Committed by Felipe Balbi

usb: dwc2: gadget: Replace phyif with phy_utmi_width

The phy utmi width information is already set in hsotg params,
phyif is only used in few places and I don't see any reason to
not use hsotg's params.

Moreover the utmi width was being forced to 16 bits by platform
initialization which doesn't take in account HW configuration.
Acked-by: default avatarMinas Harutyunyan <hminas@synopsys.com>
Signed-off-by: default avatarJules Maselbas <jmaselbas@kalray.eu>
Signed-off-by: default avatarFelipe Balbi <felipe.balbi@linux.intel.com>
parent fb26b553
......@@ -871,7 +871,6 @@ struct dwc2_hregs_backup {
* removed once all SoCs support usb transceiver.
* @supplies: Definition of USB power supplies
* @vbus_supply: Regulator supplying vbus.
* @phyif: PHY interface width
* @lock: Spinlock that protects all the driver data structures
* @priv: Stores a pointer to the struct usb_hcd
* @queuing_high_bandwidth: True if multiple packets of a high-bandwidth
......@@ -1056,7 +1055,6 @@ struct dwc2_hsotg {
struct dwc2_hsotg_plat *plat;
struct regulator_bulk_data supplies[DWC2_NUM_SUPPLIES];
struct regulator *vbus_supply;
u32 phyif;
spinlock_t lock;
void *priv;
......
......@@ -3314,20 +3314,28 @@ void dwc2_hsotg_core_init_disconnected(struct dwc2_hsotg *hsotg,
/* keep other bits untouched (so e.g. forced modes are not lost) */
usbcfg = dwc2_readl(hsotg, GUSBCFG);
/* remove the HNP/SRP */
usbcfg &= ~(GUSBCFG_TOUTCAL_MASK | GUSBCFG_PHYIF16 | GUSBCFG_SRPCAP |
GUSBCFG_HNPCAP | GUSBCFG_USBTRDTIM_MASK);
GUSBCFG_HNPCAP);
usbcfg |= GUSBCFG_TOUTCAL(7);
if (hsotg->params.phy_type == DWC2_PHY_TYPE_PARAM_FS &&
(hsotg->params.speed == DWC2_SPEED_PARAM_FULL ||
hsotg->params.speed == DWC2_SPEED_PARAM_LOW)) {
/* FS/LS Dedicated Transceiver Interface */
usbcfg |= GUSBCFG_PHYSEL;
} else {
/* set the PLL on, remove the HNP/SRP and set the PHY */
val = (hsotg->phyif == GUSBCFG_PHYIF8) ? 9 : 5;
usbcfg |= hsotg->phyif | GUSBCFG_TOUTCAL(7) |
(val << GUSBCFG_USBTRDTIM_SHIFT);
} else if (hsotg->params.phy_type == DWC2_PHY_TYPE_PARAM_UTMI) {
if (hsotg->params.phy_utmi_width == 16)
usbcfg |= GUSBCFG_PHYIF16;
/* Set turnaround time */
usbcfg &= ~GUSBCFG_USBTRDTIM_MASK;
if (hsotg->params.phy_utmi_width == 16)
usbcfg |= 5 << GUSBCFG_USBTRDTIM_SHIFT;
else
usbcfg |= 9 << GUSBCFG_USBTRDTIM_SHIFT;
}
dwc2_writel(hsotg, usbcfg, GUSBCFG);
dwc2_hsotg_init_fifo(hsotg);
......
......@@ -230,9 +230,6 @@ static int dwc2_lowlevel_hw_init(struct dwc2_hsotg *hsotg)
reset_control_deassert(hsotg->reset_ecc);
/* Set default UTMI width */
hsotg->phyif = GUSBCFG_PHYIF16;
/*
* Attempt to find a generic PHY, then look for an old style
* USB PHY and then fall back to pdata
......@@ -280,7 +277,7 @@ static int dwc2_lowlevel_hw_init(struct dwc2_hsotg *hsotg)
* width is 8-bit and set the phyif appropriately.
*/
if (phy_get_bus_width(hsotg->phy) == 8)
hsotg->phyif = GUSBCFG_PHYIF8;
hsotg->params.phy_utmi_width = 8;
}
/* Clock */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment