omap3: igepv2: LED gpio-led:green:d1 is active low

Make sure the LED is turned off at boot time, and configure the GPIO LED
device as active low.
Signed-off-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Acked-by: Enric Balletbo i Serra <eballetbo@gmail.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

arch/arm/mach-omap2/board-igep0020.c

@@ -352,6 +352,7 @@ static struct gpio_led igep2_gpio_leds[] = {
 		.name			= "gpio-led:green:d1",
 		.default_trigger	= "heartbeat",
 		.gpio			= -EINVAL, /* gets replaced */
+		.active_low		= 1,
 	},
 };
 
@@ -423,7 +424,7 @@ static int igep2_twl_gpio_setup(struct device *dev,
 	/* TWL4030_GPIO_MAX + 1 == ledB (out, active low LED) */
 #if !defined(CONFIG_LEDS_GPIO) && !defined(CONFIG_LEDS_GPIO_MODULE)
 	if ((gpio_request(gpio+TWL4030_GPIO_MAX+1, "gpio-led:green:d1") == 0)
-	    && (gpio_direction_output(gpio + TWL4030_GPIO_MAX + 1, 0) == 0))
+	    && (gpio_direction_output(gpio + TWL4030_GPIO_MAX + 1, 1) == 0))
 		gpio_export(gpio + TWL4030_GPIO_MAX + 1, 0);
 	else
 		pr_warning("IGEP v2: Could not obtain gpio GPIO_LED1_GREEN\n");