Commit 71c46897 authored by Ursula Braun's avatar Ursula Braun Committed by David S. Miller

s390/net: set HW port number in netdevice

struct net_device contains a dev_port field. Store the OSA port number
in this field.
Signed-off-by: default avatarUrsula Braun <ubraun@linux.ibm.com>
Reviewed-by: default avatarJulian Wiedmann <jwi@linux.ibm.com>
Signed-off-by: default avatarJulian Wiedmann <jwi@linux.ibm.com>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent d8de0ddf
......@@ -1928,6 +1928,8 @@ lcs_portno_store (struct device *dev, struct device_attribute *attr, const char
return -EINVAL;
/* TODO: sanity checks */
card->portno = value;
if (card->dev)
card->dev->dev_port = card->portno;
return count;
......@@ -2158,6 +2160,7 @@ lcs_new_device(struct ccwgroup_device *ccwgdev)
card->dev = dev;
card->dev->ml_priv = card;
card->dev->netdev_ops = &lcs_netdev_ops;
card->dev->dev_port = card->portno;
memcpy(card->dev->dev_addr, card->mac, LCS_MAC_LENGTH);
#ifdef CONFIG_IP_MULTICAST
if (!lcs_check_multicast_support(card))
......
......@@ -144,6 +144,8 @@ static ssize_t qeth_dev_portno_store(struct device *dev,
goto out;
}
card->info.portno = portno;
if (card->dev)
card->dev->dev_port = portno;
out:
mutex_unlock(&card->conf_mutex);
return rc ? rc : count;
......
......@@ -984,6 +984,7 @@ static int qeth_l2_setup_netdev(struct qeth_card *card)
card->dev->mtu = card->info.initial_mtu;
card->dev->min_mtu = 64;
card->dev->max_mtu = ETH_MAX_MTU;
card->dev->dev_port = card->info.portno;
card->dev->netdev_ops = &qeth_l2_netdev_ops;
if (card->info.type == QETH_CARD_TYPE_OSN) {
card->dev->ethtool_ops = &qeth_l2_osn_ops;
......
......@@ -2576,6 +2576,7 @@ static int qeth_l3_setup_netdev(struct qeth_card *card)
card->dev->mtu = card->info.initial_mtu;
card->dev->min_mtu = 64;
card->dev->max_mtu = ETH_MAX_MTU;
card->dev->dev_port = card->info.portno;
card->dev->ethtool_ops = &qeth_l3_ethtool_ops;
card->dev->features |= NETIF_F_HW_VLAN_CTAG_TX |
NETIF_F_HW_VLAN_CTAG_RX |
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment