mtd: docg3: add OOB layout to mtdinfo

Add OOB layout description for docg3, so that userspace can
use this information to setup the data for write_oob().
Signed-off-by: Robert Jarzmik <robert.jarzmik@free.fr>
Reviewed-by: Ivan Djelic <ivan.djelic@parrot.com>
Reviewed-by: Mike Dunn <mikedunn@newsguy.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>

drivers/mtd/devices/docg3.c

@@ -63,6 +63,20 @@
  *
  */
 
+/**
+ * struct docg3_oobinfo - DiskOnChip G3 OOB layout
+ * @eccbytes: 8 bytes are used (1 for Hamming ECC, 7 for BCH ECC)
+ * @eccpos: ecc positions (byte 7 is Hamming ECC, byte 8-14 are BCH ECC)
+ * @oobfree: free pageinfo bytes (byte 0 until byte 6, byte 15
+ * @oobavail: 8 available bytes remaining after ECC toll
+ */
+static struct nand_ecclayout docg3_oobinfo = {
+	.eccbytes = 8,
+	.eccpos = {7, 8, 9, 10, 11, 12, 13, 14},
+	.oobfree = {{0, 7}, {15, 1} },
+	.oobavail = 8,
+};
+
 static inline u8 doc_readb(struct docg3 *docg3, u16 reg)
 {
 	u8 val = readb(docg3->base + reg);
@@ -973,6 +987,7 @@ static void __init doc_set_driver_info(int chip_id, struct mtd_info *mtd)
 	mtd->write_oob = NULL;
 	mtd->sync = NULL;
 	mtd->block_isbad = doc_block_isbad;
+	mtd->ecclayout = &docg3_oobinfo;
 }
 
 /**