Commit 7471fb77 authored by NeilBrown's avatar NeilBrown Committed by Shaohua Li

md/raid6: Fix anomily when recovering a single device in RAID6.

When recoverying a single missing/failed device in a RAID6,
those stripes where the Q block is on the missing device are
handled a bit differently.  In these cases it is easy to
check that the P block is correct, so we do.  This results
in the P block be destroy.  Consequently the P block needs
to be read a second time in order to compute Q.  This causes
lots of seeks and hurts performance.

It shouldn't be necessary to re-read P as it can be computed
from the DATA.  But we only compute blocks on missing
devices, since c337869d ("md: do not compute parity
unless it is on a failed drive").

So relax the change made in that commit to allow computing
of the P block in a RAID6 which it is the only missing that
block.

This makes RAID6 recovery run much faster as the disk just
"before" the recovering device is no longer seeking
back-and-forth.
Reported-by-tested-by: default avatarBrad Campbell <lists2009@fnarfbargle.com>
Reviewed-by: default avatarDan Williams <dan.j.williams@intel.com>
Signed-off-by: default avatarNeilBrown <neilb@suse.com>
Signed-off-by: default avatarShaohua Li <shli@fb.com>
parent 583da48e
...@@ -3619,9 +3619,20 @@ static int fetch_block(struct stripe_head *sh, struct stripe_head_state *s, ...@@ -3619,9 +3619,20 @@ static int fetch_block(struct stripe_head *sh, struct stripe_head_state *s,
BUG_ON(test_bit(R5_Wantcompute, &dev->flags)); BUG_ON(test_bit(R5_Wantcompute, &dev->flags));
BUG_ON(test_bit(R5_Wantread, &dev->flags)); BUG_ON(test_bit(R5_Wantread, &dev->flags));
BUG_ON(sh->batch_head); BUG_ON(sh->batch_head);
/*
* In the raid6 case if the only non-uptodate disk is P
* then we already trusted P to compute the other failed
* drives. It is safe to compute rather than re-read P.
* In other cases we only compute blocks from failed
* devices, otherwise check/repair might fail to detect
* a real inconsistency.
*/
if ((s->uptodate == disks - 1) && if ((s->uptodate == disks - 1) &&
((sh->qd_idx >= 0 && sh->pd_idx == disk_idx) ||
(s->failed && (disk_idx == s->failed_num[0] || (s->failed && (disk_idx == s->failed_num[0] ||
disk_idx == s->failed_num[1]))) { disk_idx == s->failed_num[1])))) {
/* have disk failed, and we're requested to fetch it; /* have disk failed, and we're requested to fetch it;
* do compute it * do compute it
*/ */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment