i2c-bfin-twi: Add missing pin mux operation

Blackfin TWI controller hardware pin should be requested from GPIO port controller
Before BF54x, there is no need to do this. But as long as BF54x and BF52x
are supported by this generic driver, the missing pin mux operation should be
added.
Signed-off-by: Bryan Wu <cooloney@kernel.org>
Signed-off-by: Jean Delvare <khali@linux-fr.org>

drivers/i2c/busses/i2c-bfin-twi.c

@@ -34,6 +34,7 @@
 #include <linux/platform_device.h>
 
 #include <asm/blackfin.h>
+#include <asm/portmux.h>
 #include <asm/irq.h>
 
 #define POLL_TIMEOUT       (2 * HZ)
@@ -89,6 +90,11 @@ DEFINE_TWI_REG(XMT_DATA16, 0x84)
 DEFINE_TWI_REG(RCV_DATA8, 0x88)
 DEFINE_TWI_REG(RCV_DATA16, 0x8C)
 
+static const u16 pin_req[2][3] = {
+	{P_TWI0_SCL, P_TWI0_SDA, 0},
+	{P_TWI1_SCL, P_TWI1_SDA, 0},
+};
+
 static void bfin_twi_handle_interrupt(struct bfin_twi_iface *iface)
 {
 	unsigned short twi_int_status = read_INT_STAT(iface);
@@ -653,6 +659,12 @@ static int i2c_bfin_twi_probe(struct platform_device *pdev)
 	p_adap->class = I2C_CLASS_ALL;
 	p_adap->dev.parent = &pdev->dev;
 
+	rc = peripheral_request_list(pin_req[pdev->id], "i2c-bfin-twi");
+	if (rc) {
+		dev_err(&pdev->dev, "Can't setup pin mux!\n");
+		goto out_error_pin_mux;
+	}
+
 	rc = request_irq(iface->irq, bfin_twi_interrupt_entry,
 		IRQF_DISABLED, pdev->name, iface);
 	if (rc) {
@@ -690,6 +702,8 @@ static int i2c_bfin_twi_probe(struct platform_device *pdev)
 	free_irq(iface->irq, iface);
 out_error_req_irq:
 out_error_no_irq:
+	peripheral_free_list(pin_req[pdev->id]);
+out_error_pin_mux:
 	iounmap(iface->regs_base);
 out_error_ioremap:
 out_error_get_res:
@@ -706,6 +720,7 @@ static int i2c_bfin_twi_remove(struct platform_device *pdev)
 
 	i2c_del_adapter(&(iface->adap));
 	free_irq(iface->irq, iface);
+	peripheral_free_list(pin_req[pdev->id]);
 	iounmap(iface->regs_base);
 	kfree(iface);