Commit 7676679f authored by FUJITA Tomonori's avatar FUJITA Tomonori Committed by Linus Torvalds

mn10300: use asm-generic/scatterlist.h

Signed-off-by: default avatarFUJITA Tomonori <fujita.tomonori@lab.ntt.co.jp>
Cc: David Howells <dhowells@redhat.com>
Cc: Koichi Yasutake <yasutake.koichi@jp.panasonic.com>
Signed-off-by: default avatarAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: default avatarLinus Torvalds <torvalds@linux-foundation.org>
parent 3e6e3da8
...@@ -11,45 +11,8 @@ ...@@ -11,45 +11,8 @@
#ifndef _ASM_SCATTERLIST_H #ifndef _ASM_SCATTERLIST_H
#define _ASM_SCATTERLIST_H #define _ASM_SCATTERLIST_H
#include <asm/types.h> #include <asm-generic/scatterlist.h>
/*
* Drivers must set either ->address or (preferred) page and ->offset
* to indicate where data must be transferred to/from.
*
* Using page is recommended since it handles highmem data as well as
* low mem. ->address is restricted to data which has a virtual mapping, and
* it will go away in the future. Updating to page can be automated very
* easily -- something like
*
* sg->address = some_ptr;
*
* can be rewritten as
*
* sg_set_page(virt_to_page(some_ptr));
* sg->offset = (unsigned long) some_ptr & ~PAGE_MASK;
*
* and that's it. There's no excuse for not highmem enabling YOUR driver. /jens
*/
struct scatterlist {
#ifdef CONFIG_DEBUG_SG
unsigned long sg_magic;
#endif
unsigned long page_link;
unsigned int offset; /* for highmem, page offset */
dma_addr_t dma_address;
unsigned int length;
};
#define ISA_DMA_THRESHOLD (0x00ffffff) #define ISA_DMA_THRESHOLD (0x00ffffff)
/*
* These macros should be used after a pci_map_sg call has been done
* to get bus addresses of each of the SG entries and their lengths.
* You should only work with the number of sg entries pci_map_sg
* returns.
*/
#define sg_dma_address(sg) ((sg)->dma_address)
#define sg_dma_len(sg) ((sg)->length)
#endif /* _ASM_SCATTERLIST_H */ #endif /* _ASM_SCATTERLIST_H */
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment