media: i2c: imx290: Simplify imx290_set_data_lanes()

There's no need to check for an incorrect number of data lanes in
imx290_set_data_lanes() as the value is validated at probe() time. Drop
the check.

The PHY_LANE_NUM and CSI_LANE_MODE registers are programmed with a value
equal to the number of lanes minus one. Compute it instead of handling
it in the switch/case.
Signed-off-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Reviewed-by: Alexander Stein <alexander.stein@ew.tq-group.com>
Signed-off-by: Sakari Ailus <sakari.ailus@linux.intel.com>
Signed-off-by: Mauro Carvalho Chehab <mchehab@kernel.org>

drivers/media/i2c/imx290.c

@@ -512,28 +512,21 @@ static int imx290_set_register_array(struct imx290 *imx290,
 
 static int imx290_set_data_lanes(struct imx290 *imx290)
 {
-	int ret = 0, laneval, frsel;
+	int ret = 0;
+	u32 frsel;
 
 	switch (imx290->nlanes) {
 	case 2:
-		laneval = 0x01;
+	default:
 		frsel = 0x02;
 		break;
 	case 4:
-		laneval = 0x03;
 		frsel = 0x01;
 		break;
-	default:
-		/*
-		 * We should never hit this since the data lane count is
-		 * validated in probe itself
-		 */
-		dev_err(imx290->dev, "Lane configuration not supported\n");
-		return -EINVAL;
 	}
 
-	imx290_write(imx290, IMX290_PHY_LANE_NUM, laneval, &ret);
-	imx290_write(imx290, IMX290_CSI_LANE_MODE, laneval, &ret);
+	imx290_write(imx290, IMX290_PHY_LANE_NUM, imx290->nlanes - 1, &ret);
+	imx290_write(imx290, IMX290_CSI_LANE_MODE, imx290->nlanes - 1, &ret);
 	imx290_write(imx290, IMX290_FR_FDG_SEL, frsel, &ret);
 
 	return ret;