Commit 76c930be authored by Fabio Estevam's avatar Fabio Estevam Committed by Brian Norris

mtd: gpmi-lib: Make checkpatch happy

Fix the following checkpatch warnings:

WARNING: line over 80 characters
#268: FILE: mtd/nand/gpmi-nand/gpmi-lib.c:268:
+	* consecutive reboots. The latter case has not been seen on the MX23 yet,

WARNING: space prohibited before semicolon
#356: FILE: mtd/nand/gpmi-nand/gpmi-lib.c:356:
+		(target.tRHOH_in_ns >= 0) ;

WARNING: space prohibited before semicolon
#1006: FILE: mtd/nand/gpmi-nand/gpmi-lib.c:1006:
+		BF_GPMI_TIMING0_DATA_SETUP(hw.data_setup_in_cycles)       ;
Signed-off-by: default avatarFabio Estevam <fabio.estevam@freescale.com>
Acked-by: default avatarHuang Shijie <b32955@freescale.com>
Signed-off-by: default avatarBrian Norris <computersforpeace@gmail.com>
parent 554cbc50
......@@ -265,8 +265,8 @@ int bch_set_geometry(struct gpmi_nand_data *this)
* chip, otherwise it will lock up. So we skip resetting BCH on the MX23.
* On the other hand, the MX28 needs the reset, because one case has been
* seen where the BCH produced ECC errors constantly after 10000
* consecutive reboots. The latter case has not been seen on the MX23 yet,
* still we don't know if it could happen there as well.
* consecutive reboots. The latter case has not been seen on the MX23
* yet, still we don't know if it could happen there as well.
*/
ret = gpmi_reset_block(r->bch_regs, GPMI_IS_MX23(this));
if (ret)
......@@ -353,7 +353,7 @@ static int gpmi_nfc_compute_hardware_timing(struct gpmi_nand_data *this,
improved_timing_is_available =
(target.tREA_in_ns >= 0) &&
(target.tRLOH_in_ns >= 0) &&
(target.tRHOH_in_ns >= 0) ;
(target.tRHOH_in_ns >= 0);
/* Inspect the clock. */
nfc->clock_frequency_in_hz = clk_get_rate(r->clock[0]);
......@@ -1003,7 +1003,7 @@ void gpmi_begin(struct gpmi_nand_data *this)
/* [1] Set HW_GPMI_TIMING0 */
reg = BF_GPMI_TIMING0_ADDRESS_SETUP(hw.address_setup_in_cycles) |
BF_GPMI_TIMING0_DATA_HOLD(hw.data_hold_in_cycles) |
BF_GPMI_TIMING0_DATA_SETUP(hw.data_setup_in_cycles) ;
BF_GPMI_TIMING0_DATA_SETUP(hw.data_setup_in_cycles);
writel(reg, gpmi_regs + HW_GPMI_TIMING0);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment