Commit 77581df8 authored by Sven Eckelmann's avatar Sven Eckelmann Committed by Kalle Valo

dt: bindings: add new dt entry for ath11k calibration variant

The bus + qmi-chip-id + qmi-board-id is not enough to identify the correct
board data file on IPQ6018 based devices. Multiple different boards share
the same values. Only the original reference designs can currently be
identified and loaded from the board-2.bin. But these will not result in
the correct calibration data when combined with the pre-calibration data
from the device.

An additional "variant" information has to be provided to select the
correct board data for a design which was modified by an ODM. This follows
the same approach as ath10k.
Signed-off-by: default avatarSven Eckelmann <sven@narfation.org>
Reviewed-by: default avatarRob Herring <robh@kernel.org>
Signed-off-by: default avatarKalle Valo <kvalo@codeaurora.org>
Link: https://lore.kernel.org/r/20201015131501.1939685-1-sven@narfation.org
parent bafdbd79
......@@ -144,6 +144,12 @@ properties:
* reg
* reg-names
qcom,ath11k-calibration-variant:
$ref: /schemas/types.yaml#/definitions/string
description:
string to uniquely identify variant of the calibration data in the
board-2.bin for designs with colliding bus and device specific ids
required:
- compatible
- reg
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment