Commit 7891d375 authored by Pavel Machek's avatar Pavel Machek Committed by Lee Jones

mfd: ti-lmu: Use managed resource for everything

This replaces all remaining unmanaged resources with device
managed ones, so that the remove function is no longer needed.
This makes the code slightly shorter and fixes two problems:

 1. The hardware is disabled after the child devices have
    been removed. Previously there was a potential race
    condition.
 2. The hardware is disabled when mfd_add_devices fails
    during probe.
Signed-off-by: default avatarSebastian Reichel <sebastian.reichel@collabora.co.uk>
Signed-off-by: default avatarPavel Machek <pavel@ucw.cz>
Signed-off-by: default avatarLee Jones <lee.jones@linaro.org>
parent 7a6a395b
......@@ -47,8 +47,9 @@ static int ti_lmu_enable_hw(struct ti_lmu *lmu, enum ti_lmu_id id)
return 0;
}
static void ti_lmu_disable_hw(struct ti_lmu *lmu)
static void ti_lmu_disable_hw(void *data)
{
struct ti_lmu *lmu = data;
if (lmu->en_gpio)
gpiod_set_value(lmu->en_gpio, 0);
}
......@@ -205,6 +206,10 @@ static int ti_lmu_probe(struct i2c_client *cl, const struct i2c_device_id *id)
if (ret)
return ret;
ret = devm_add_action_or_reset(dev, ti_lmu_disable_hw, lmu);
if (ret)
return ret;
/*
* Fault circuit(open/short) can be detected by ti-lmu-fault-monitor.
* After fault detection is done, some devices should re-initialize
......@@ -214,17 +219,8 @@ static int ti_lmu_probe(struct i2c_client *cl, const struct i2c_device_id *id)
i2c_set_clientdata(cl, lmu);
return mfd_add_devices(lmu->dev, 0, data->cells,
data->num_cells, NULL, 0, NULL);
}
static int ti_lmu_remove(struct i2c_client *cl)
{
struct ti_lmu *lmu = i2c_get_clientdata(cl);
ti_lmu_disable_hw(lmu);
mfd_remove_devices(lmu->dev);
return 0;
return devm_mfd_add_devices(lmu->dev, 0, data->cells,
data->num_cells, NULL, 0, NULL);
}
static const struct i2c_device_id ti_lmu_ids[] = {
......@@ -240,7 +236,6 @@ MODULE_DEVICE_TABLE(i2c, ti_lmu_ids);
static struct i2c_driver ti_lmu_driver = {
.probe = ti_lmu_probe,
.remove = ti_lmu_remove,
.driver = {
.name = "ti-lmu",
.of_match_table = ti_lmu_of_match,
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment