btrfs: zoned: mark block groups to copy for device-replace
This is the 1/4 patch to support device-replace on zoned filesystems. We have two types of IOs during the device replace process. One is an IO to "copy" (by the scrub functions) all the device extents from the source device to the destination device. The other one is an IO to "clone" (by handle_ops_on_dev_replace()) new incoming write IOs from users to the source device into the target device. Cloning incoming IOs can break the sequential write rule in on target device. When a write is mapped in the middle of a block group, the IO is directed to the middle of a target device zone, which breaks the sequential write requirement. However, the cloning function cannot be disabled since incoming IOs targeting already copied device extents must be cloned so that the IO is executed on the target device. We cannot use dev_replace->cursor_{left,right} to determine whether a bio is going to a not yet copied region. Since we have a time gap between finishing btrfs_scrub_dev() and rewriting the mapping tree in btrfs_dev_replace_finishing(), we can have a newly allocated device extent which is never cloned nor copied. So the point is to copy only already existing device extents. This patch introduces mark_block_group_to_copy() to mark existing block groups as a target of copying. Then, handle_ops_on_dev_replace() and dev-replace can check the flag to do their job. Also, btrfs_finish_block_group_to_copy() will check if the copied stripe is the last stripe in the block group. With the last stripe copied, the to_copy flag is finally disabled. Afterwards we can safely clone incoming IOs on this block group. Reviewed-by: Josef Bacik <josef@toxicpanda.com> Signed-off-by: Naohiro Aota <naohiro.aota@wdc.com> Signed-off-by: David Sterba <dsterba@suse.com>
Showing
Please register or sign in to comment