firmware: arm_scmi: Fix possible scmi_linux_errmap buffer overflow

The scmi_linux_errmap buffer access index is supposed to depend on the
array size to prevent element out of bounds access. It uses SCMI_ERR_MAX
to check bounds but that can mismatch with the array size. It also
changes the success into -EIO though scmi_linux_errmap is never used in
case of success, it is expected to work for success case too.

It is slightly confusing code as the negative of the error code
is used as index to the buffer. Fix it by negating it at the start and
make it more readable.

Link: https://lore.kernel.org/r/20210707135028.1869642-1-sudeep.holla@arm.comReported-by: kernel test robot <lkp@intel.com>
Reported-by: Dan Carpenter <dan.carpenter@oracle.com>
Reviewed-by: Cristian Marussi <cristian.marussi@arm.com>
Signed-off-by: Sudeep Holla <sudeep.holla@arm.com>

drivers/firmware/arm_scmi/driver.c

@@ -47,7 +47,6 @@ enum scmi_error_codes {
 	SCMI_ERR_GENERIC = -8,	/* Generic Error */
 	SCMI_ERR_HARDWARE = -9,	/* Hardware Error */
 	SCMI_ERR_PROTOCOL = -10,/* Protocol Error */
-	SCMI_ERR_MAX
 };
 
 /* List of all SCMI devices active in system */
@@ -166,8 +165,10 @@ static const int scmi_linux_errmap[] = {
 
 static inline int scmi_to_linux_errno(int errno)
 {
-	if (errno < SCMI_SUCCESS && errno > SCMI_ERR_MAX)
-		return scmi_linux_errmap[-errno];
+	int err_idx = -errno;
+
+	if (err_idx >= SCMI_SUCCESS && err_idx < ARRAY_SIZE(scmi_linux_errmap))
+		return scmi_linux_errmap[err_idx];
 	return -EIO;
 }