Commit 7a72eddc authored by Ondrej Zary's avatar Ondrej Zary Committed by David S. Miller

tlan: Don't disable internal PHY on cards that use it in 10 Mbps mode

In tlan_reset_adapter, we disable internal PHY when an external one is used.
On cards which use internal PHY in 10 Mbps mode, we enable it later when
setting 10 Mbps mode but it does not really work (PHY fails to reset).
Leave it enabled instead.
Signed-off-by: default avatarOndrej Zary <linux@rainbow-software.org>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent 9cff441e
......@@ -2237,7 +2237,9 @@ tlan_reset_adapter(struct net_device *dev)
}
}
if (priv->phy_num == 0)
/* don't power down internal PHY if we're going to use it */
if (priv->phy_num == 0 ||
(priv->adapter->flags & TLAN_ADAPTER_USE_INTERN_10))
data |= TLAN_NET_CFG_PHY_EN;
tlan_dio_write16(dev->base_addr, TLAN_NET_CONFIG, (u16) data);
......@@ -2688,7 +2690,6 @@ static void tlan_phy_finish_auto_neg(struct net_device *dev)
struct tlan_priv *priv = netdev_priv(dev);
u16 an_adv;
u16 an_lpa;
u16 data;
u16 mode;
u16 phy;
u16 status;
......@@ -2721,9 +2722,6 @@ static void tlan_phy_finish_auto_neg(struct net_device *dev)
(priv->adapter->flags & TLAN_ADAPTER_USE_INTERN_10) &&
(priv->phy_num != 0)) {
priv->phy_num = 0;
data = TLAN_NET_CFG_1FRAG | TLAN_NET_CFG_1CHAN
| TLAN_NET_CFG_PHY_EN;
tlan_dio_write16(dev->base_addr, TLAN_NET_CONFIG, data);
tlan_set_timer(dev, (400*HZ/1000), TLAN_TIMER_PHY_PDOWN);
return;
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment