Merge tag 'imx-fixes-5.16-3' of...

Merge tag 'imx-fixes-5.16-3' of git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux into arm/fixes

i.MX fixes for 5.16, round 3:

- Fix imx6qdl-wandboard Ethernet support by adding 'qca,clk-out-frequency'
  property.
- Fix scl-gpios property typo in LX2160A device tree.

* tag 'imx-fixes-5.16-3' of git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux:
  arm64: dts: lx2160a: fix scl-gpios property name
  ARM: dts: imx6qdl-wandboard: Fix Ethernet support
  soc: imx: Register SoC device only on i.MX boards
  soc: imx: imx8m-blk-ctrl: Fix imx8mm mipi reset
  ARM: dts: imx6ull-pinfunc: Fix CSI_DATA07__ESAI_TX0 pad name
  arm64: dts: imx8mq: remove interconnect property from lcdif
  arm64: dts: ten64: remove redundant interrupt declaration for gpio-keys
  arm64: dts: lx2160abluebox3: update RGMII delays for sja1105 switch
  ARM: dts: ls1021a-tsn: update RGMII delays for sja1105 switch
  ARM: dts: imx6qp-prtwd3: update RGMII delays for sja1105 switch

Link: https://lore.kernel.org/r/20211218052003.GA25102@dragonSigned-off-by: Arnd Bergmann <arnd@arndb.de>

arch/arm/boot/dts/imx6qdl-wandboard.dtsi

@@ -309,6 +309,7 @@ mdio {
 
 		ethphy: ethernet-phy@1 {
 			reg = <1>;
+			qca,clk-out-frequency = <125000000>;
 		};
 	};
 };

arch/arm/boot/dts/imx6qp-prtwd3.dts

@@ -178,6 +178,8 @@ port@4 {
 				label = "cpu";
 				ethernet = <&fec>;
 				phy-mode = "rgmii-id";
+				rx-internal-delay-ps = <2000>;
+				tx-internal-delay-ps = <2000>;
 
 				fixed-link {
 					speed = <100>;

arch/arm/boot/dts/imx6ull-pinfunc.h

@@ -82,6 +82,6 @@
 #define MX6ULL_PAD_CSI_DATA04__ESAI_TX_FS                         0x01F4 0x0480 0x0000 0x9 0x0
 #define MX6ULL_PAD_CSI_DATA05__ESAI_TX_CLK                        0x01F8 0x0484 0x0000 0x9 0x0
 #define MX6ULL_PAD_CSI_DATA06__ESAI_TX5_RX0                       0x01FC 0x0488 0x0000 0x9 0x0
-#define MX6ULL_PAD_CSI_DATA07__ESAI_T0                            0x0200 0x048C 0x0000 0x9 0x0
+#define MX6ULL_PAD_CSI_DATA07__ESAI_TX0                           0x0200 0x048C 0x0000 0x9 0x0
 
 #endif /* __DTS_IMX6ULL_PINFUNC_H */

arch/arm/boot/dts/ls1021a-tsn.dts

@@ -91,6 +91,8 @@ port@4 {
 				/* Internal port connected to eth2 */
 				ethernet = <&enet2>;
 				phy-mode = "rgmii";
+				rx-internal-delay-ps = <0>;
+				tx-internal-delay-ps = <0>;
 				reg = <4>;
 
 				fixed-link {

arch/arm64/boot/dts/freescale/fsl-ls1088a-ten64.dts

@@ -38,7 +38,6 @@ buttons {
 		powerdn {
 			label = "External Power Down";
 			gpios = <&gpio1 17 GPIO_ACTIVE_LOW>;
-			interrupts = <&gpio1 17 IRQ_TYPE_EDGE_FALLING>;
 			linux,code = <KEY_POWER>;
 		};
 
@@ -46,7 +45,6 @@ powerdn {
 		admin {
 			label = "ADMIN button";
 			gpios = <&gpio3 8 GPIO_ACTIVE_HIGH>;
-			interrupts = <&gpio3 8 IRQ_TYPE_EDGE_RISING>;
 			linux,code = <KEY_WPS_BUTTON>;
 		};
 	};

arch/arm64/boot/dts/freescale/fsl-lx2160a-bluebox3.dts

@@ -386,6 +386,8 @@ port@2 {
 				reg = <2>;
 				ethernet = <&dpmac17>;
 				phy-mode = "rgmii-id";
+				rx-internal-delay-ps = <2000>;
+				tx-internal-delay-ps = <2000>;
 
 				fixed-link {
 					speed = <1000>;
@@ -529,6 +531,8 @@ port@2 {
 				reg = <2>;
 				ethernet = <&dpmac18>;
 				phy-mode = "rgmii-id";
+				rx-internal-delay-ps = <2000>;
+				tx-internal-delay-ps = <2000>;
 
 				fixed-link {
 					speed = <1000>;

arch/arm64/boot/dts/freescale/fsl-lx2160a.dtsi

@@ -719,7 +719,7 @@ i2c0: i2c@2000000 {
 			clock-names = "i2c";
 			clocks = <&clockgen QORIQ_CLK_PLATFORM_PLL
 					    QORIQ_CLK_PLL_DIV(16)>;
-			scl-gpio = <&gpio2 15 GPIO_ACTIVE_HIGH>;
+			scl-gpios = <&gpio2 15 GPIO_ACTIVE_HIGH>;
 			status = "disabled";
 		};
 
@@ -768,7 +768,7 @@ i2c4: i2c@2040000 {
 			clock-names = "i2c";
 			clocks = <&clockgen QORIQ_CLK_PLATFORM_PLL
 					    QORIQ_CLK_PLL_DIV(16)>;
-			scl-gpio = <&gpio2 16 GPIO_ACTIVE_HIGH>;
+			scl-gpios = <&gpio2 16 GPIO_ACTIVE_HIGH>;
 			status = "disabled";
 		};
 

arch/arm64/boot/dts/freescale/imx8mq.dtsi

@@ -524,8 +524,6 @@ lcdif: lcd-controller@30320000 {
 						  <&clk IMX8MQ_VIDEO_PLL1>,
 						  <&clk IMX8MQ_VIDEO_PLL1_OUT>;
 				assigned-clock-rates = <0>, <0>, <0>, <594000000>;
-				interconnects = <&noc IMX8MQ_ICM_LCDIF &noc IMX8MQ_ICS_DRAM>;
-				interconnect-names = "dram";
 				status = "disabled";
 
 				port@0 {

drivers/soc/imx/imx8m-blk-ctrl.c

@@ -17,6 +17,7 @@
 
 #define BLK_SFT_RSTN	0x0
 #define BLK_CLK_EN	0x4
+#define BLK_MIPI_RESET_DIV	0x8 /* Mini/Nano DISPLAY_BLK_CTRL only */
 
 struct imx8m_blk_ctrl_domain;
 
@@ -36,6 +37,15 @@ struct imx8m_blk_ctrl_domain_data {
 	const char *gpc_name;
 	u32 rst_mask;
 	u32 clk_mask;
+
+	/*
+	 * i.MX8M Mini and Nano have a third DISPLAY_BLK_CTRL register
+	 * which is used to control the reset for the MIPI Phy.
+	 * Since it's only present in certain circumstances,
+	 * an if-statement should be used before setting and clearing this
+	 * register.
+	 */
+	u32 mipi_phy_rst_mask;
 };
 
 #define DOMAIN_MAX_CLKS 3
@@ -78,6 +88,8 @@ static int imx8m_blk_ctrl_power_on(struct generic_pm_domain *genpd)
 
 	/* put devices into reset */
 	regmap_clear_bits(bc->regmap, BLK_SFT_RSTN, data->rst_mask);
+	if (data->mipi_phy_rst_mask)
+		regmap_clear_bits(bc->regmap, BLK_MIPI_RESET_DIV, data->mipi_phy_rst_mask);
 
 	/* enable upstream and blk-ctrl clocks to allow reset to propagate */
 	ret = clk_bulk_prepare_enable(data->num_clks, domain->clks);
@@ -99,6 +111,8 @@ static int imx8m_blk_ctrl_power_on(struct generic_pm_domain *genpd)
 
 	/* release reset */
 	regmap_set_bits(bc->regmap, BLK_SFT_RSTN, data->rst_mask);
+	if (data->mipi_phy_rst_mask)
+		regmap_set_bits(bc->regmap, BLK_MIPI_RESET_DIV, data->mipi_phy_rst_mask);
 
 	/* disable upstream clocks */
 	clk_bulk_disable_unprepare(data->num_clks, domain->clks);
@@ -120,6 +134,9 @@ static int imx8m_blk_ctrl_power_off(struct generic_pm_domain *genpd)
 	struct imx8m_blk_ctrl *bc = domain->bc;
 
 	/* put devices into reset and disable clocks */
+	if (data->mipi_phy_rst_mask)
+		regmap_clear_bits(bc->regmap, BLK_MIPI_RESET_DIV, data->mipi_phy_rst_mask);
+
 	regmap_clear_bits(bc->regmap, BLK_SFT_RSTN, data->rst_mask);
 	regmap_clear_bits(bc->regmap, BLK_CLK_EN, data->clk_mask);
 
@@ -480,6 +497,7 @@ static const struct imx8m_blk_ctrl_domain_data imx8mm_disp_blk_ctl_domain_data[]
 		.gpc_name = "mipi-dsi",
 		.rst_mask = BIT(5),
 		.clk_mask = BIT(8) | BIT(9),
+		.mipi_phy_rst_mask = BIT(17),
 	},
 	[IMX8MM_DISPBLK_PD_MIPI_CSI] = {
 		.name = "dispblk-mipi-csi",
@@ -488,6 +506,7 @@ static const struct imx8m_blk_ctrl_domain_data imx8mm_disp_blk_ctl_domain_data[]
 		.gpc_name = "mipi-csi",
 		.rst_mask = BIT(3) | BIT(4),
 		.clk_mask = BIT(10) | BIT(11),
+		.mipi_phy_rst_mask = BIT(16),
 	},
 };
 

drivers/soc/imx/soc-imx.c

@@ -36,6 +36,10 @@ static int __init imx_soc_device_init(void)
 	int ret;
 	int i;
 
+	/* Return early if this is running on devices with different SoCs */
+	if (!__mxc_cpu_type)
+		return 0;
+
 	if (of_machine_is_compatible("fsl,ls1021a"))
 		return 0;