Commit 7b001bff authored by Mauro Carvalho Chehab's avatar Mauro Carvalho Chehab Committed by Jonathan Corbet

lzo.txt: standardize document format

Each text file under Documentation follows a different
format. Some doesn't even have titles!

Change its representation to follow the adopted standard,
using ReST markups for it to be parseable by Sphinx:

- Add markups for section titles;
- mark literal blocks;
- use ".. important::" for an important note.
Signed-off-by: default avatarMauro Carvalho Chehab <mchehab@s-opensource.com>
Signed-off-by: default avatarJonathan Corbet <corbet@lwn.net>
parent c926d4d4
===========================================================
LZO stream format as understood by Linux's LZO decompressor
===========================================================
Introduction
============
This is not a specification. No specification seems to be publicly available
for the LZO stream format. This document describes what input format the LZO
......@@ -14,12 +15,13 @@ Introduction
for future bug reports.
Description
===========
The stream is composed of a series of instructions, operands, and data. The
instructions consist in a few bits representing an opcode, and bits forming
the operands for the instruction, whose size and position depend on the
opcode and on the number of literals copied by previous instruction. The
operands are used to indicate :
operands are used to indicate:
- a distance when copying data from the dictionary (past output buffer)
- a length (number of bytes to copy from dictionary)
......@@ -38,7 +40,7 @@ Description
of bits in the operand. If the number of bits isn't enough to represent the
length, up to 255 may be added in increments by consuming more bytes with a
rate of at most 255 per extra byte (thus the compression ratio cannot exceed
around 255:1). The variable length encoding using #bits is always the same :
around 255:1). The variable length encoding using #bits is always the same::
length = byte & ((1 << #bits) - 1)
if (!length) {
......@@ -67,15 +69,19 @@ Description
instruction may encode this distance (0001HLLL), it takes one LE16 operand
for the distance, thus requiring 3 bytes.
IMPORTANT NOTE : in the code some length checks are missing because certain
instructions are called under the assumption that a certain number of bytes
follow because it has already been guaranteed before parsing the instructions.
They just have to "refill" this credit if they consume extra bytes. This is
an implementation design choice independent on the algorithm or encoding.
.. important::
In the code some length checks are missing because certain instructions
are called under the assumption that a certain number of bytes follow
because it has already been guaranteed before parsing the instructions.
They just have to "refill" this credit if they consume extra bytes. This
is an implementation design choice independent on the algorithm or
encoding.
Byte sequences
==============
First byte encoding :
First byte encoding::
0..17 : follow regular instruction encoding, see below. It is worth
noting that codes 16 and 17 will represent a block copy from
......@@ -91,7 +97,7 @@ Byte sequences
state = 4 [ don't copy extra literals ]
skip byte
Instruction encoding :
Instruction encoding::
0 0 0 0 X X X X (0..15)
Depends on the number of literals copied by the last instruction.
......@@ -156,6 +162,7 @@ Byte sequences
distance = (H << 3) + D + 1
Authors
=======
This document was written by Willy Tarreau <w@1wt.eu> on 2014/07/19 during an
analysis of the decompression code available in Linux 3.16-rc5. The code is
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment