Commit 7be0670f authored by Dirk Behme's avatar Dirk Behme Committed by Greg Kroah-Hartman

tty: serial: imx: don't reinit clock in imx_setup_ufcr()

Remove the clock configuration from imx_setup_ufcr(). This
isn't needed here and will cause garbage output if done.

To be be sure that we only touch the bits we want (TXTL and RXTL)
we have to mask out all other bits of the UFCR register. Add
one non-existing bit macro for this, too (bit 6, DCEDTE on i.MX6).
Signed-off-by: default avatarDirk Behme <dirk.behme@de.bosch.com>
CC: Shawn Guo <shawn.guo@linaro.org>
CC: Sascha Hauer <s.hauer@pengutronix.de>
CC: Troy Kisky <troy.kisky@boundarydevices.com>
CC: Xinyu Chen <xinyu.chen@freescale.com>
Cc: stable <stable@vger.kernel.org>
Acked-by: default avatarShawn Guo <shawn.guo@linaro.org>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 9ec1882d
......@@ -132,6 +132,7 @@
#define UCR4_OREN (1<<1) /* Receiver overrun interrupt enable */
#define UCR4_DREN (1<<0) /* Recv data ready interrupt enable */
#define UFCR_RXTL_SHF 0 /* Receiver trigger level shift */
#define UFCR_DCEDTE (1<<6) /* DCE/DTE mode select */
#define UFCR_RFDIV (7<<7) /* Reference freq divider mask */
#define UFCR_RFDIV_REG(x) (((x) < 7 ? 6 - (x) : 6) << 7)
#define UFCR_TXTL_SHF 10 /* Transmitter trigger level shift */
......@@ -667,22 +668,11 @@ static void imx_break_ctl(struct uart_port *port, int break_state)
static int imx_setup_ufcr(struct imx_port *sport, unsigned int mode)
{
unsigned int val;
unsigned int ufcr_rfdiv;
/* set receiver / transmitter trigger level.
* RFDIV is set such way to satisfy requested uartclk value
*/
val = TXTL << 10 | RXTL;
ufcr_rfdiv = (clk_get_rate(sport->clk_per) + sport->port.uartclk / 2)
/ sport->port.uartclk;
if(!ufcr_rfdiv)
ufcr_rfdiv = 1;
val |= UFCR_RFDIV_REG(ufcr_rfdiv);
/* set receiver / transmitter trigger level */
val = readl(sport->port.membase + UFCR) & (UFCR_RFDIV | UFCR_DCEDTE);
val |= TXTL << UFCR_TXTL_SHF | RXTL;
writel(val, sport->port.membase + UFCR);
return 0;
}
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment