Commit 7c4ebe68 authored by Roger Quadros's avatar Roger Quadros Committed by Greg Kroah-Hartman

USB: ehci-omap: Don't select any PHY driver

Don't select NOP_USB_XCEIV. Instead, board config
must select USB_PHY and the appropriate PHY driver.

Also add a hint in Kconfig so that users enabling
this driver manually enable the right PHY drivers as well.

Gets rid of the below warnings when USB_EHCI_HCD_OMAP
is enabled.

warning: (USB_EHCI_HCD_OMAP) selects NOP_USB_XCEIV which has unmet direct dependencies (USB_SUPPORT && USB_PHY)
warning: (USB_EHCI_HCD_OMAP) selects NOP_USB_XCEIV which has unmet direct dependencies (USB_SUPPORT && USB_PHY)
Signed-off-by: default avatarRoger Quadros <rogerq@ti.com>
Acked-by: default avatarAlan Stern <stern@rowland.harvard.edu>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 1361bf4b
...@@ -150,11 +150,13 @@ config USB_EHCI_MXC ...@@ -150,11 +150,13 @@ config USB_EHCI_MXC
config USB_EHCI_HCD_OMAP config USB_EHCI_HCD_OMAP
tristate "EHCI support for OMAP3 and later chips" tristate "EHCI support for OMAP3 and later chips"
depends on ARCH_OMAP depends on ARCH_OMAP
select NOP_USB_XCEIV
default y default y
---help--- ---help---
Enables support for the on-chip EHCI controller on Enables support for the on-chip EHCI controller on
OMAP3 and later chips. OMAP3 and later chips.
If your system uses a PHY on the USB port, you will need to
enable USB_PHY and the appropriate PHY driver as well. Most
boards need the NOP_USB_XCEIV PHY driver.
config USB_EHCI_HCD_ORION config USB_EHCI_HCD_ORION
tristate "Support for Marvell EBU on-chip EHCI USB controller" tristate "Support for Marvell EBU on-chip EHCI USB controller"
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment