arm64: dts: allwinner: h6: Add MMC1 pins

MMC1 is used on some H6 boards we want to support. Typical use is 4-bit
SDIO interface with a WiFi chip. Add pin definitions for this use case.

As this is the only possible configration for mmc1, make it the default
one, too.
Signed-off-by: Ondrej Jirman <megous@megous.com>
Signed-off-by: Maxime Ripard <maxime.ripard@bootlin.com>

arch/arm64/boot/dts/allwinner/sun50i-h6.dtsi

@@ -243,6 +243,15 @@ mmc0_pins: mmc0-pins {
 				bias-pull-up;
 			};
 
+			/omit-if-no-ref/
+			mmc1_pins: mmc1-pins {
+				pins = "PG0", "PG1", "PG2", "PG3",
+				       "PG4", "PG5";
+				function = "mmc1";
+				drive-strength = <30>;
+				bias-pull-up;
+			};
+
 			mmc2_pins: mmc2-pins {
 				pins = "PC1", "PC4", "PC5", "PC6",
 				       "PC7", "PC8", "PC9", "PC10",
@@ -294,6 +303,8 @@ mmc1: mmc@4021000 {
 			resets = <&ccu RST_BUS_MMC1>;
 			reset-names = "ahb";
 			interrupts = <GIC_SPI 36 IRQ_TYPE_LEVEL_HIGH>;
+			pinctrl-names = "default";
+			pinctrl-0 = <&mmc1_pins>;
 			status = "disabled";
 			#address-cells = <1>;
 			#size-cells = <0>;