media: camss: csid-170: remove stray comment

This is a leftover from my original patches, it doesn't serve any purpose.
(it was a reminder to figure out how downstream sets a particular field in
the register).

Fixes: eebe6d00 ("media: camss: Add support for CSID hardware version Titan 170")
Signed-off-by: Jonathan Marek <jonathan@marek.ca>
Reviewed-by: Robert Foss <robert.foss@linaro.org>
Tested-by: Julian Grahsl <jgrahsl@snap.com>
Tested-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab@kernel.org>

drivers/media/platform/qcom/camss/camss-csid-170.c

@@ -442,7 +442,7 @@ static void csid_configure_stream(struct csid_device *csid, u8 enable)
 
 	val = 1 << CSI2_RX_CFG1_PACKET_ECC_CORRECTION_EN;
 	val |= 1 << CSI2_RX_CFG1_MISR_EN;
-	writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG1); // csi2_vc_mode_shift_val ?
+	writel_relaxed(val, csid->base + CSID_CSI2_RX_CFG1);
 
 	val = 1 << RDI_CTRL_HALT_CMD;
 	writel_relaxed(val, csid->base + CSID_RDI_CTRL(0));