[SCSI] qla2xxx: Use correct Request-Q-Out register during bidirectional request processing

Original code was not corrected for ISP83xx support. Instead code should used
the cached reference from the req_que structure, rather than the legacy
'if (ISP-TYPE(X))... else if (ISP-TYPE(Y))...' codes.
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: Saurav Kashyap <saurav.kashyap@qlogic.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>

drivers/scsi/qla2xxx/qla_iocb.c

@@ -2748,7 +2748,6 @@ qla2x00_start_bidir(srb_t *sp, struct scsi_qla_host *vha, uint32_t tot_dsds)
 	struct rsp_que *rsp;
 	struct req_que *req;
 	int rval = EXT_STATUS_OK;
-	device_reg_t __iomem *reg = ISP_QUE_REG(ha, vha->req->id);
 
 	rval = QLA_SUCCESS;
 
@@ -2786,15 +2785,7 @@ qla2x00_start_bidir(srb_t *sp, struct scsi_qla_host *vha, uint32_t tot_dsds)
 
 	/* Check for room on request queue. */
 	if (req->cnt < req_cnt + 2) {
-		if (ha->mqenable)
-			cnt = RD_REG_DWORD(&reg->isp25mq.req_q_out);
-		else if (IS_QLA82XX(ha))
-			cnt = RD_REG_DWORD(&reg->isp82.req_q_out);
-		else if (IS_FWI2_CAPABLE(ha))
-			cnt = RD_REG_DWORD(&reg->isp24.req_q_out);
-		else
-			cnt = qla2x00_debounce_register(
-					ISP_REQ_Q_OUT(ha, &reg->isp));
+		cnt = RD_REG_DWORD_RELAXED(req->req_q_out);
 
 		if  (req->ring_index < cnt)
 			req->cnt = cnt - req->ring_index;