Commit 7ff6b232 authored by Toshi Kikuchi's avatar Toshi Kikuchi Committed by Bryan Wu

Documentation: leds-lp5523: describe master fader attributes

Add the usage of the new attributes for master faders.
Signed-off-by: default avatarToshi Kikuchi <toshik@chromium.org>
Acked-by: default avatarMilo Kim <milo.kim@ti.com>
Acked-by: default avatarJacek Anaszewski <j.anaszewski@samsung.com>
Signed-off-by: default avatarBryan Wu <cooloney@gmail.com>
parent 52da81ea
......@@ -49,6 +49,36 @@ There are two ways to run LED patterns.
2) Firmware interface - LP55xx common interface
For the details, please refer to 'firmware' section in leds-lp55xx.txt
LP5523 has three master faders. If a channel is mapped to one of
the master faders, its output is dimmed based on the value of the master
fader.
For example,
echo "123000123" > master_fader_leds
creates the following channel-fader mappings:
channel 0,6 to master_fader1
channel 1,7 to master_fader2
channel 2,8 to master_fader3
Then, to have 25% of the original output on channel 0,6:
echo 64 > master_fader1
To have 0% of the original output (i.e. no output) channel 1,7:
echo 0 > master_fader2
To have 100% of the original output (i.e. no dimming) on channel 2,8:
echo 255 > master_fader3
To clear all master fader controls:
echo "000000000" > master_fader_leds
Selftest uses always the current from the platform data.
Each channel contains led current settings.
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment