wimax: allow WIMAX_RF_QUERY calls when state is still uninitialized

Until now, calls to wimax_rfkill() will be blocked until the device is
at least past the WIMAX_ST_UNINITIALIZED state, return -ENOMEDIUM when
the device is in the WIMAX_ST_DOWN state.

In parallel, wimax-tools would issue a wimax_rfkill(WIMAX_RF_QUERY)
call right after opening a handle with wimaxll_open() as means to
verify if the interface is really a WiMAX interface [newer kernel
version will have a call specifically for this].

The combination of these two facts is that in some cases, before the
driver has finalized initializing its device's firmware, a
wimaxll_open() call would fail, when it should not.

Thus, change the wimax_rfkill() code to allow queries when the device
is in WIMAX_ST_UNINITIALIZED state.
Signed-off-by: Inaky Perez-Gonzalez <inaky@linux.intel.com>

net/wimax/op-rfkill.c

@@ -305,8 +305,15 @@ int wimax_rfkill(struct wimax_dev *wimax_dev, enum wimax_rf_state state)
 	d_fnstart(3, dev, "(wimax_dev %p state %u)\n", wimax_dev, state);
 	mutex_lock(&wimax_dev->mutex);
 	result = wimax_dev_is_ready(wimax_dev);
-	if (result < 0)
+	if (result < 0) {
+		/* While initializing, < 1.4.3 wimax-tools versions use
+		 * this call to check if the device is a valid WiMAX
+		 * device; so we allow it to proceed always,
+		 * considering the radios are all off. */
+		if (result == -ENOMEDIUM && state == WIMAX_RF_QUERY)
+			result = WIMAX_RF_OFF << 1 | WIMAX_RF_OFF;
 		goto error_not_ready;
+	}
 	switch (state) {
 	case WIMAX_RF_ON:
 	case WIMAX_RF_OFF: